User's Manual

6
Remote control installation
6 720 606 990
Electrical str ip connectors
B At the ignition electrodes, pull off the
2 yellow igniter wires that come from
the top of the control unit (Fig. 2,
pos. 3). Then pull the complete
control unit forward and out of the
heater, pull up the power supply
cord further if more slack is needed.
B While holding the unit in one hand or
resting it on a flat surface, remove
the front cover of the control unit by
removing the 4 screws.
Remote control transceiver PCB
installation
B Open control unit top cover (Fig. 3,
pos. 1).
B Remove the protective paper (Fig. 3,
pos. 2) from one face of the support
and attach it to the main PCB as
shown in Fig. 4.
Fig. 3
B Remove the other protective paper
and attach the remote control PCB
as shown in Fig. 5.
Once auxiliary
cover is off, pull
off the two
electrical strip
connectors from
the board. Once
off, the wiring
harness can be
removed from the
case by pulling
their rubber seals
outward.
6720606990-0701_(Remote control)16Nov.fm Page 6 Friday, November 16, 2007 3:04 PM