User manual

12 | English
F 016 L81 090 | (11.2.16) Bosch Power Tools
 Examine the machine and replace worn or damaged parts
for safety.
 Grease the blade cassette with a multi purpose grease con-
taining high viscosity mineral oil every 70 hours through
the correct lubrication point. See figure 7 of illustrations.
 Use lubrication spray directly on the blade after every use.
 Keep all nuts, bolts and screws tight to ensure that the
hedgecutter is always in a safe working condition.
Cleaning
 Always clean the machine after each use. Clean exterior
surfaces thoroughly using a soft brush and cloth. Do not
clean with water, solvents or polishes.
Recommendations for Optimal Handling of the
Battery and Charger
 Warning! Do not attempt to charge non rechargeable bat-
teries with the charger.
 Inserting the battery pack into the machine with the switch
on is dangerous.
 Ensure battery is the right way up.
 Insert the battery until the locking mechanism clicks. To re-
move the battery, operate locking lever. Take care not to
drop the battery through the hole.
 For care use and maintenance please use charger and bat-
tery manuals which are supplied with the products or avail-
able at www.bosch-professional.com.
Symbols
The following symbols are important for reading and under-
standing the operating instructions. Please take note of the
symbols and their meaning. The correct interpretation of the
symbols will help you to use the machine in a better and safer
manner.
Intended Use
The garden product is intended for Professional use.
Technical Data
Only LI-Ion batteries GBA 36V series (Art No. 1 607 A35 .../ …) and battery charger AL36100 CV series (Art No. 1 600 A001..)
can be used with this machine.
Please do not use non-rechargeable batteries with this appliance, only those specified by the manufacturer.
Symbol Meaning
Read instruction manual.
Wear protective gloves.
Wear foot protection.
Oiling required
Movement direction
Reaction direction
Switching On
Switching Off
Accessories
Weight
Cordless hedge trimmer GHE 60 R GHE 60 T GHE 70 R
Blade type
roughing trimming roughing
Article number
3 600 J12 000 3 600 J12 001 3 600 J12 002
No-load stroke rate
min
-1
3000 3000 3000
Cutting length
mm 600 600 700
Tooth opening
mm 28 23 28
Tooth pitch
mm 35 30 35
Handle Rotation
° +90/0/-90 +90/0/-90 +90/0/-90
Sharpening Angle
°4545 45
Weight (without batteries)
according to EPTA-Procedure 01:2014
kg 5.0 5.0 5.3
Serial number
See serial number (type plate) on the machine
OBJ_BUCH-2419-003.book Page 12 Thursday, February 11, 2016 9:51 AM