- Dremel High Performance Rotary Tool Instructional Safety Manual 400 Series XPR

For availability of all accessories and attachments, refer your local hardware, hobby or home
center. Or contact Dremel Consumer Service at:
1-800-437-3635 or at www.Dremel.com.
Use only Dremel™, high-performance accessories. Other accessories are
not designed for this tool and may lead to personal injury or property
damage.
Screw Mandrel
For use with the felt polishing
tip and felt polishing wheels.
Mandrels
A mandrel is a shank with a threaded or
screw head used with polishing accessories,
cutting wheels, sanding discs and polishing
points. The mandrel is a permanent shank,
allowing for replacement of the worn head
when necessary.
Drywall Cutting Bit
When using a template (outlet box) behind
the drywall, cut in a counterclockwise direc-
tion.
16
ACCESSORIES
Multipurpose Cutting Bit
For use in wood, plastics, drywall, fiberglass,
vinyl or aluminum siding, acoustical tile and
laminates.
Start the bit into the material at a 45° angle
and then slowly bring it to a 90° angle to
begin the cut.
High Speed Router Bits
For routing, inlaying and mortising in wood
and other soft materials. Use only with
Dremel™ Router Attachment #330 or
Shape/Router Table #231.
WARNING
!
Tile Cutting Bit
For use wall tile, cement board and plaster.
Start the bit into the material at a 45° angle
and then slowly bring it to a 90° angle to
begin the cut.
Small Screw Mandrel
Mandrel has a small screw
at the tip and is used with
emery and fiberglass cutting
wheels, sanding discs and
polishing wheels.
Threaded Tip Mandrel
Mandrel has a threaded tip
which threads into the polish-
ing point accessory #427.
Diamond Wheel Points
Used for fine detail work on
wood, jade, ceramic, glass and
other hard material. Bits are
covered with diamond parti
-
cles.
Aluminum Oxide Grinding
Stones (red/brown)
These grinding stones
come round, pointed or flat
and are made of aluminum
oxide. Use them for every possible grinding
operation: sharpening lawn mower blades,
screwdriver tips, knives, scissors, chisels and
other cutting tools. Use to remove flash from
metal castings, deburring any kind of metal.
These grinding stones can be resharpened
with a dressing stone. In machine shops,
high speed drills and cutters are normally
ground with aluminum oxide wheels.
Silicon Carbide Grinding
Stones (blue/green)
Tougher than aluminum oxide
points, these are made especially for use on
hard materials such as glass and ceramics.
1/8" shank
1/8" shank
1/8" shank
1/8" shank
1/8" shank
3/32" shank