Replacement Part List

Y95116 GENEVIEVE FOUNTAIN W/ LIGHTS VERSION 01

Assembly and Instructions

Notes:

1. Choose an appropriate location for your fountain.

2. While fountain is designed to operate as splash free as possible, some water

splashing out of the fountain is inevitable. Place your fountain in a location where any

splashing will not cause damage.

3. The National Electric Code requires that a ground fault circuit interrupter (GFCI) be

used in the branch circuit supplying fountain pump and other pond equipment. See

your electrical supplies dealer for this device.

4. Keep your fountain full of water and clean of debris and dirt to ensure proper

functioning of the pump.

5. Place your fountain on a level surface, away from areas where it is likely to get

clogged with leaves and make sure that the cable will reach the socket.

6. If necessary, clean your fountain with a soft cloth and change the water frequently.

Due to water evaporation, you may see a buildup of white residue on the fountain

surface from mineral content in the water supply. To prevent such buildup, regularly

clean your fountain with soap and water, do not use any abrasive, which may damage

the applied finish.

Assembly Instructions

1. Get the plug and hose of the pump out of the product.

2. Connect the flexible hose to pump outlet, and place the pump in the bottom of the

reservoir.

3. Cover the cover at the back.

4. Get the fountain top to fountain base, make sure it is stable before continuing.

5. Fill the reservoir with water and make sure the water can submerge the pump fully to

prevent pump damage.

6. Plug in and switch on of the two plugs, after a short while the water will start to flow.

7. Adjust the pump flow rate to achieve the desired effect and to minimize any splashing.

Splashing can occur if the flow rate is too high or the reservoir is too full. The flow rate

can be increased or decreased by moving the flow rate control slider on the pump

body. Moving the switch towards clockwise or anticlockwise to increase or decrease

the flow rate.

PAGE 1
Y95116 GENEVIEVE FOUNTAIN W/ LIGHTS Assembly and Instructions VERSION 01 Notes: 1. Choose an appropriate location for your fountain. 2. While fountain is designed to operate as splash free as possible, some water splashing out of the fountain is inevitable. Place your fountain in a location where any splashing will not cause damage. 3. The National Electric Code requires that a ground fault circuit interrupter (GFCI) be used in the branch circuit supplying fountain pump and other pond equipment.
PAGE 2
Y95116 GENEVIEVE FOUNTAIN W/ LIGHTS VERSION 01 Troubleshooting 1. If pump does not run, check the circuit breaker, try another outlet. 2. Check the water level in the fountain. Running the pump without sufficient water can damage the pump. 3. Check the setting of the flow control on the pump. 4. Check the pump discharge and intake for dirt and debris. 5. Check the fountain feature tubing for kinks and obstructions. 6. Is the pump “air locked”? Plug and unplug the pump several times to clear.