Installation Guide

Wall-Mounted Installation
www.BOCCHIUSA.com
3
• Unpack the sink and inspect for defects. If you have any questions, contact BOCCHI immediately toll-free at
877-565-2221 or email BOCCHI directly at [e-mail]
X
Y
• Locate the measurement of the bolt holes on the sink
• Mark the holes on the wall so that the sink will be installed in the
suggested height of 32 inches*.
*NOTE: If you are using console legs with the wall-hung sink, consult
the instructions provided with the leg set to ensure the bolt holes for
the sink are placed at the proper height for the leg set being used.
This may vary from the standard 32 inches.
• Make sure that there is proper backing in the wall to carry the
weight of the sink. NOTE: sink weights will vary, please check
the weight for your specific model number and prepare the wall
according to the weight of your model.
X
Y
• Use the drill and coordinating drill-bit type and size for the wall
material , to drill the bolt holes.
• Install the bolt(s) delivered with the sink. If drilling directly into
wood, do not use the supplied anchors.
• Hang the sink onto the bolts and slide the plastic spacer and
washer over the bolt(s), followed by the metal washer and nut.
• Level the sink and use the adjustable wrench, or a
standard 13mm wrench, to tighten the nut onto the bolts.
CAUTION: DO NOT overtighten!
1st Plastic spacer 2nd Metal Washer 3rd Nut