Owners manual

Page 6 of 8 292-3000 Rev. D 8/31/10
11.Using the fl at screwdriver, remove three
pushpins on the bottom and remove the black
plastic piece. Set pushpins and plastic aside
to be reinstalled later.
12. Using the utility knife, on the inside of the
fascia trim the fog light housing bumps, on the
bottom trim back 2” and on the top trim 1 1/2”,
fl ush with the plastic surface.
13. Slide the baseplate onto the frame rails 1 1/2”
back from the bumper bracket aligning the
front air baffl e hole with the front middle hole
of the baseplate. Align the top edge of the
endplate with the top edge of the frame rail
and clamp in place using the large vise grips.
Hold the fascia up to its original position and
verify the convenience links, electrical rods
and attachment tabs come through the fascia
opening.
2008-11 Ford Focus SES (Manual Transmission)
Installation Instructions
BX2199
Ô
Ô
Ô
Ô
Ô
Ô
11
11
12
12
Ô
Ô
13
13
Ô
Ô
14
14
Ô
Ô
Ô
Ô
14. Using the baseplate as a template, drill four
corner holes into the frame webbing with the
13/32” drill bit. Insert 3/8”-16 x 1 1/4” hex bolts
into holes and tighten to the 1/4” lock washers
and 3/8-16 hex nuts.
Ô
Ô
Ô
Ô
Ô
Ô
BE SURE TO USE LOCTITE
®
RED ON ALL BOLTS
BEFORE TIGHTENING. TIGHTEN ALL BOLTS
ACCORDING TO THE TORQUE CHART ON THE
FRONT PAGE OF THESE INSTRUCTIONS OR ON
PAGE 3 OF THE BASEPLATE TOWING GENERAL
INSTRUCTIONS.
When using power drills be aware of the
dangers of torque and drill bit length.