TPP240 TPP240 ® ® air purifier with uv light air purifier with uv light by TP240-051410 owner’s guide by
table of contents Thank you for purchasing the Therapure® 240 air purifier.
2 3 safety instructions important warnings Save these instructions UV Lamp Notice UV Light is harmful to bare skin and eyes and can cause temporary or permanent loss of vision. Never look directly at the UV lamp while it is illuminated; doing so could cause loss of vision! Only view illumination through the window at the front of the unit. To prevent exposure to ultraviolet light, disconnect the power to the unit before servicing any part of the Therapure® 240 air purifier.
5 product benefits main parts » Quadruple action purification: 1. Locking Latch 2. Air Inlet Grill 3. Permanent HEPA Type Filter: the permanent filter removes small visible and non-visible particles down to 0.1 microns in size. 4. UV Lamp Cover 5. Control Panel 6. LED Display 7. Power Button 8. ION Button 9. UV/VOC Button: the germicidal UV/VOC light is used to kill harmful airborne bacteria, germs and viruses and reduce harmful VOC (volatile organic compounds). 10.
6 7 operating the therapure® 240 operating the therapure® 240 Before using the Therapure® 240 air purifier, please read the following important information. Electrical Ratings: 120V Setting: 120Vac, 60 Hz Power consumption: 55 watts at high fan speed, 3 watt UV light bulb Net weight: 10.3 lbs. Dimension (LxWxH): 9.6” x 7.9” x 26.1” Safety 1. Do not place near fans. 2. Keep both sides of the unit at least 1 foot away from a wall. 3 Do not place the unit near curtains. 4.
8 9 operating the therapure® 240 cleaning & maintenance Controls/Settings Power Control – To operate the Therapure® 240 air purifier,press the “ON/OFF” button to turn on the air purifier, press the button again to turn off the air purifier. Timer Control – The Therapure® 240 air purifier can be programmed to turn off after a preset amount of time. Press the “TIMER” button to program the timer. Each press will add one hour up to a total of 24 hours.
10 11 cleaning & maintenance cleaning & maintenance Cleaning External Surfaces 1. Turn off and unplug unit. 2. Use a washcloth slightly dampened with a little water and dishwashing soap to wipe the outer case surfaces. 3. Do not allow water to slip into the internal parts as this could damage your unit and result in electrical shock and injury to you. 4. Allow the unit to thoroughly dry before use. Before replacing the UV lamp, make sure the Therapure® air purifier is turned off and unplugged.
12 13 troubleshooting one-year limited warranty Problem Reason Solution Unit will not operate. Power button has not been turned on. Press the Power button Unit is unplugged. Check to ensure unit is plugged in. The inlet grill has not been installed & locked into place. Check to make sure filter is properly installed & locked into place. Reduced airflow or poor filtering. The inlet or outlet grill may be blocked. Check to ensure nothing is blocking air inlet & air outlet.
