Blaze® Electric Grill Owner’s Manual BLZ-ELEC-21 Optional pedestal mount shown ATTENTION INSTALLER: PLEASE LEAVE THESE INSTRUCTIONS WITH THE CONSUMER. CONSUMER: PLEASE READ & RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE AND BEFORE INSTALLING OR OPERATING. WARNING Observe all local codes and ordinances when installing this appliance. If no local codes are applicable, wire unit in accordance with the latest Na�onal Electrical Code, ANSI/NFPA 70, or the Canadian Electrical Code, CSA C22.
• • • • • • WARNING If the informa�on in this manual is not followed exactly, a fire or explosion may result, causing property damage, personal injury, or loss of life. WARNING Read the installa�on, opera�on, and maintenance instruc�ons thoroughly before installing, opera�ng, or servicing this equipment to reduce risk of fire, burn hazard, or other injury. This manual should be retained for your informa�on. Do not operate this electric grill without having read this manual.
Table of Contents Product Specifications 4-5 Warnings 6 Parts List 7 Locating the Appliance 8 Installation and Assembly 9-12 Operation 13 Drip Tray 13 Care and Cleaning 14 Troubleshooting 15 Warranty Information 16 Product Registration 17 3
THIS MANUAL APPLIES TO THE FOLLOWING BLAZE GRILLS Model: BLZ-ELEC-21 Cutout Dimensions 21”W x 18 1/4”D x 9 5/8”H* *These dimensions create the required air gap underneath this appliance. This air gap serves multiple purposes, such as preventing a build up of heat in the island cavity and helping provide proper airflow to keep the unit cool.
GRILL SPECIFICATIONS NOTE: ALWAYS have equipment measured by a contractor before beginning any project. *These dimensions create the required air gap underneath this appliance.
WARNING • THIS APPLIANCE IS HOT WHEN OPERATING AND CAN CAUSE SEVERE BURNS. • Do not install damaged, incomplete, or substitute components. • Young children should be carefully supervised when they are in the same room as the appliance. Toddlers, young children, and others may be susceptible to accidental burns. A physical barrier should be used if there are any at-risk individuals in the home.
Parts List 1. Lid 2. M8 Nut (2pcs) 3. M8 Flat Gasket (2pcs) 4. Lid Hinge (2pcs) 5. Thermometer 6. Thermometer Base 7. Thermemoter Seal 8. Lid Handle 9. Warming Rack (1pcs) 10. Cooking Grate (2pcs) 11. Heating Element 12. Flame Tamer (2pcs) 13. Probe Protecting Tube 14. Back Heating Element Attachment Bracket 15. Front Heating Element Attachment Bracket 16. Hang-In Side Bracket (2pcs) 17. Hang-In Back Bracket 18. Grill Body 19. Thermostat 20. LED Light 21. Time Adjuster 22. Knob Base (2pcs) 23.
Location of Appliance This unit is not to be used in altitudes above 6,561.68 feet (2,000 meters). Most importantly, this is an outdoor appliance. Under no circumstance is this appliance to be used indoors. This includes garages or any other enclosed area. This outdoor electric cooking appliance is not approved to be installed in or on any recreational vehicles and/or boats. Blaze Grills are for single family/residential use only.
Installation and Assembly Ensuring Proper Airflow Proper airflow MUST be maintained for the grill to perform as it was designed. If airflow is blocked, overheating will result. Do not block more than 75% of the cooking grid surface with pans or griddles. WARNING: NEVER cover the entire cooking or grill surface with griddles or pans. Overheating of the electronic components will occur. CAUTION: DO NOT operate this grill with air blowing into or across the rear oven lid vent.
Installation and Assembly cont. Pedestal Models Reference the figure below when installing your pedestal electric grill. 1. Using a Phillips-head screwdriver, remove the 4 screws and bumpers on the bottom of the grill. Discard the bumpers. Align the electric grill onto the top of the post assembly. Using the same 4 screws, fasten the electric grill to the post assembly. 2.
Installation and Assembly cont. Pedestal Model Specifications Countertop Models Be sure the unit is stationed on a clean, dry, and level surface, and that all clearance and location requirements on the previous page are met. Reference the figure below when installing your countertop electric grill. 1. Place the grill on a level, non-combustible surface. 2. Using the adjustable feet, ensure the unit is level and free from wobble. 3.
Installation and Assembly cont. Built-In Models Reference the figures below and to the right when installing your built-in electric grill. 1. Using a Phillips-head screwdriver, remove the 4 screws on the side of the grill and bumpers on the bottom of the grill. Discard the bumpers. 2. Using the same 4 screws, fasten the electric grill built-in brackets to the unit. 3. Carefully lift the unit and slide into the islands pre-cut hole. Built-in specifications and regulations can be found on pages 4, 5, and 7.
Operation Cooking Element Turning on your Electric Grill: 1. Plug power cord into a dedicated GFCI outlet. 2. Ensure power cord surge protector is reset. 3. Turn timer on to desired cook time. 4. Turn on heating element with left power control knob. 5. For maximum performance, allow the grill to preheat for 10 minutes before cooking. *Note: To ensure maximum performance plug grill into its own dedicated 20 amp circuit. Drop-Down Shelf 1.
Care and Cleaning NOTE: Always wait until your appliance is completely cool before cleaning. Do not clean this product with a water spray or the like. You should clean your appliance after each use to maintain the overall appearance over the life of your appliance. After the first use, it is normal for your appliance to become discolored in certain areas from the heat produced by the heating element.
Troubleshooting SAFETY INFORMATION WARNING DISCONNECT THE APPLIANCE COMPLETELY AND LET COOL PRIOR TO ANY SERVICE. ONLY A QUALIFIED SERVICE PERSON SHOULD SERVICE AND REPAIR THIS ELECTRIC APPLIANCE. Problem Possible Cause Solution 1. Grill does not work. 1. Power failure. 1. Check if power is available. 2. Power not plugged correctly. 2. Make sure the power cord plug is properly inserted into the receptacle. 3. GFI plug may be tripped. 3. Reset switches on the GFI receptacle. 1. No power to unit.
Warranty Registration If you have purchased a Blaze Grill, you must register your product within 30 days of purchase to validate the warranty and maintain your original receipt to get parts for the appliance. You may register your appliance at www.blazegrills.com by selecting Support, and then selecting Register your Product. The warranty is for original owners only at the original site of delivery and cannot be transferred to new owners. You must retain your sales slip or invoice for warranty to apply.
Blaze Product Registration Please take a minute to let us know what you bought. This ensures we keep you up to date and have your info ready if you ever need warranty help! You may register your product electronically on the Blaze website blazegrills.com.