Blaze Drop-In Single Side Burner Manual
Table Of Contents
- USE & CARE GUIDE
- ATTENTION:
- INSTALLER: PLEASE LEAVE THESE INSTRUCTIONS WITH THE CONSUMER.
- I. Burner Specifications 4
- II. General Safety and Installation Warnings 5-8
- i. Location of Appliance 8-10
- III. Electrical Safety and Installation Warnings 11-12
- IV. Gas Safety and Installation Warnings 12-13
- i. Checking for Gas Leaks 14-16
- ii. Unpacking Unit 16
- V. Gas Connections 17
- i. Natural Gas Requirements 17
- ii. Liquid Propane Gas and Tank Requirements 17-18
- iii. Transporting and Storing LP Gas 18-19
- VI. Installing the Appliance in a BBQ Island 20
- i. Outdoor Kitchen Ventilation 21-23
- ii. Building BBQ Specifications + Instruction Diagrams 23-24
- VII. First Time Operation 25
- i. Lighting the Appliance 25-26
- ii. Manually Lighting the Appliance 26
- iii. Flame Adjustment 26-27
- VIII. Cleaning your Appliance 27-28
- NOTE: ALWAYS have equipment measured by Contractor before beginning any project.
- Single Side Burner Cut Out
- Do not attempt to heat unopened containers on the burner as pressure may build up and cause the container to explode.
- Never use charcoal or any other solid fuel in the appliance.
- Never cook without the drip pan in place.
- Never operate this appliance while under the influence of alcohol or drugs.
- Location of Appliance
- Gas Safety and Installation Warnings
- IMPORTANT: Never connect the appliance to an unregulated gas supply.
- If there are local codes that apply to outdoor burners, you will have to conform to them. Installation must conform with local codes or in the absence of local codes, to the National Fuel Gas Code, ANSI Z223.1/NFPA 54 and Natural Gas Installation Code...
- Leak Testing
- NEVER USE AN OPEN FLAME TO CHECK FOR LEAKS.
- Natural Gas Requirements
- Liquid Propane (LP) Gas and Tank Requirements
- Installing the Appliance in a BBQ Island
- FIRST TIME OPERATION
- Cleaning Your Appliance
- Fuel Conversion
- Blaze Outdoor Products, Warranty Registration, 6620 Greenwell Springs Rd.
- Baton Rouge, LA 70805
BLAZE Instructional Book
Page | 19
closed.
2. Turn all of the burner knobs to the OFF position.
3. Connect the 3/8” Flare end of the hose to the 3/8” Flare end of the brass coupling on the unit
using a 3/4” open wrench.
Do not apply pipe sealant. (These are flared fittings.) Note: remember
the rubber line on the hose and regulator must be protected from sharp edges, hot surfaces,
aggressive building materials that could cut, melt, or damage the line. A separate approved gas line
might be needed to go between the hose and regulator and the appliance to position the rubber line
in a safe location.
4. Connect the regulator to the LP cylinder. Only hand-tighten the regulator.
5. Check for leaks using a soapy water solution by spraying on all connections, including all of the
valves, fittings, lines etc. (any and all gas connections have the ability leak and therefore it is critical
to check for leaks before each use)
6. To disconnect after you have used the appliance, turn the burner knobs to the OFF position.
7. Close the Cylinder Valve by turning the Hand Wheel counter-clockwise until it stops.
8. Disconnect the regulator from the LP cylinder after use.