Blaze Portable Manual
Table Of Contents
- USE & CARE GUIDE
- ATTENTION:
- - CONTACT INFORMATION –
- NOTE:
- FOR YOUR SAFETY
- If you smell gas:
- When using your Blaze appliance, please read and follow these basic precautions:
- Have an ABC Fire Extinguisher accessible at all times. Never attempt to extinguish a grease fire with water or other liquids.
- This unit is for outdoor use only!
- Please read all instructions before installing or operating your gas appliance to prevent injury and appliance damage.
- Location of Appliance
- - CONTACT INFORMATION –
- Electrical Safety and Installation Warnings
- Although your Blaze Portable Grill doesn’t use electricity, the following safety instructions and warnings should be followed around the grill and cooking area.
- ATTENTION:
- Gas Safety and Installation Warnings
- Gas Connections
- Cleaning Your Appliance
- Exterior Cleaning
- Flame Tamers, Cooking Grids and Warming Racks
- Cast Stainless Steel Burner
- Drip Tray & Internal Cleaning
- Warning: Due to the compact design of a portable grill, the drippings from cooking accumulate at a faster rate than a full sized grill. The inner body of the grill should be cleaned before each use to eliminate the buildup of grease and potential f...
- BLZ-1PRO-PRT / BLZ-1PRO-PRTMG
- For Your Records:
Blaze Outdoor Products Instructional Book
Page | 20
•
Turn control knobs and cylinder valve to the OFF position. Unscrew valve.
•
Remove cylinder and have it filled at your local qualified propane dealer.
•
Once filled, carefully connect the valve and make sure it is secure and not leaking.
•
With the control knobs in the OFF position, turn on the cylinder valve.
If you smell gas or hear a hiss of gas escaping from the tank, get away from the tank and do not attempt to correct
the problem yourself. Call the Fire Department immediately.
If your appliance has no leak at the cylinder, then re-check for loose connections and retest for leaks using the
method detailed in the following pages with soapy solution.
Do not subject your LP gas cylinder to excessive heat, and always store the cylinder in an upright position. Never
store your LP cylinders indoors.
Make sure that when attaching components, all connections are secured and fully tightened to prevent leakage.
Always check for leaks before every use.
Transporting and Storing LP Gas
Transport only one cylinder at a time. Ensure the cylinder is secured in an upright position with the control valve
turned off and the dust cap in place. Store cylinders outdoors and out of the reach of children. Do not store cylinders
in a building, garage, or any other enclosed area.
Procedure for LP Gas Cylinder Connection
1.
Turn all of the burner knobs to the OFF position.
2.
Turn the “Hand Wheel” on cylinder clockwise until it stops to ensure the Cylinder Valve is fully
closed.
3.
Connect the 3/8” Flare end of the hose to the 3/8” Flare end of the brass coupling on the unit using
a 3/4” open wrench. Do not apply pipe sealant. (These are flared fittings). Note: remember the
rubber line on the hose and regulator must be protected from sharp edges, hot surfaces, aggressive
Filling and Refilling LP Gas Cylinders: