Manualshelf

Specification Sheet

ManualsBrandsBlaze Grills ManualsBBQsBlaze Grills 66,000 BTU 32 Inch Wide Built-In Four Burner Natural Gas Grill with Built-In Lighting System
31323334353637383940
Blaze Outdoor Products Instructional Book
Page | 31
Version 1.1
setting.
d. Inspect burners for proper flame appearance. The ideal flame appearance is one that is mostly blue
and not lifting off of the burner surface. There is an air shutter found at the end of the burner (close to
the valve) which can be either opened or closed to make adjustments to the flame's appearance. To
adjust, remove the burner from the appliance and loosen the phillips head screw holding the air shutter
to the burner. If the flame is yellow, open the air shutter to make the flame bluer. If the flame is lifting off
of the burner surface, slightly close the air shutter. Re-tighten the phillips head screw and re-install the
burner to recheck the flame appearance. Repeat if necessary.
e. Turn burners to low flame setting and test for proper flame height. Flame should be stable and
burning out of each burner port without danger of going out in the lowest setting.
(To adjust the LOW
flame setting simply light the appliance on the LOW setting and adjust
the screw located under the
knob on the front of the valve using a flat head screwdriver as seen in the
diagram below.)
Cleaning Your Appliance
NOTE: You should clean your appliance after each use to maintain the overall appearance over the life of your
appliance. After the first use, it is normal for your appliance to become discolored in certain areas from the heat
produced by the burners. A video for cleaning your grill is located on the blaze website to assist with the below
instructions, www.blazegrills.com
.
Exterior Cleaning
When cleaning your appliance, always scrub and polish in the direction of the stainless steel grain. Wipe down
the
exterior of the appliance to remove any splatter or grease. Do not use harsh abrasives. Use a stainless
steel
cleaner to clean the exterior surface for a polished look. To remove baked-on foods, use a fine to medium
grit non-
metallic abrasive pad with a stainless steel cleaner to avoid specks of grease collecting in the grain
causing the
appearance of rust. Before installing the cover, always allow the surface to dry. DO NOT cover a
damp appliance.
Low flame setting
screw