Manualshelf

Instructions / Assembly

ManualsBrandsBlaze Grills ManualsBBQsBlaze Grills 66,000 BTU 32 Inch Wide Built-In Four Burner Natural Gas Grill with Built-In Lighting System
21222324252627282930
Blaze Outdoor Products Instructional Book
Page | 30
and not lifting off of the burner surface. There is an air shutter found at the end of the burner (close to
the valve) which can be either opened or closed to make adjustments to the flame's appearance. To
adjust, remove the burner from the appliance and loosen the Philips head screw holding the air shutter
to the burner. If the flame is yellow, open the air shutter to make the flame bluer. If the flame is lifting off
the burner surface, slightly close the air shutter. Re-tighten the Philips head screw and re-install the
burner to recheck the flame appearance. Repeat if necessary. Turn burners to low flame setting and
test for proper flame height. Flame should be stable and burning out of each burner port without danger
of going out in the lowest setting. (To adjust the LOW flame setting simply light the appliance on the
LOW setting and adjust the screw located under the knob on the front of the valve using a flat head
screwdriver as seen in the diagram below.)
Cleaning Your Appliance
NOTE: Always wait until your appliance is completely cool before cleaning. You should clean your appliance
after each use to maintain the overall appearance over the life of your appliance. After the first use, it is normal for
your appliance to become discolored in certain areas from the heat produced by the burners. A video for cleaning your
grill is located on the blaze website to assist with the below instructions, www.blazegrills.com
.
Exterior Cleaning
When cleaning your appliance, always scrub and polish in the direction of the stainless steel grain. Wipe down the
exterior of the appliance to remove any splatter or grease. Do not use harsh abrasives. Use a stainless steel cleaner
to clean the exterior surface for a polished look. To remove baked-on foods, use a fine to medium grit non- metallic
abrasive pad with a stainless steel cleaner to avoid specks of grease collecting in the grain causing the appearance
of rust. Before installing the cover, always allow the surface to dry. DO NOT cover a damp appliance.
Low flame setting
screw