Manualshelf

Instructions / Assembly

ManualsBrandsBlaze Grills ManualsBBQsBlaze Grills 66,000 BTU 32 Inch Wide Built-In Four Burner Natural Gas Grill with Built-In Lighting System
11121314151617181920
Blaze Outdoor Products Instructional Book
Page | 12
Electrical Safety and Installation Warnings
Extension cords may be used if care is exercised in their use. If
an extension cord is used:
The marked electrical rating of the cord set or extension cord should be at least as great as the electrical
rating of the appliance
The cord should be arranged so that it will not touch hot surfaces, sharp edges or drape over the
countertop or tabletop (where it can be pulled or tripped over unintentionally).
Outdoor extension cords should be used with products suited for outdoor use. They are surface marked with
suffix letters "W" or "W-A" and with a tag stating "Suitable for Use with Outdoor Appliances".
To protect against electrical shock, the power cord and plug should be kept dry and off of the ground. Do
not clean this product with water spray; do not spray cleaners into the lamp socket area.
Gasoline, lighter fluid or other flammable liquids and vapors should never be stored in the area of this appliance
or any other appliance.
Before installation or service, disconnect the power supply to the work area by removing the fuse, "tripping" the
circuit breaker, or unplugging the unit.
NOTE: Use a 15 AMP Breaker with GFI protection.
NOTE: This grill uses a “Transformer” to provide power to the LED lights and internal lights. This diagram shows
the connection to the transformer.
Keep any electrical supply cord and fuel supply hose away from any heated surfaces, sharp edges and
dripping grease.
Be certain your appliance is properly installed and grounded by a qualified technician in accordance with
applicable codes. To guarantee the electrical safety of this appliance, continuity must exist between the
appliance and an effective grounding system. It is imperative that this basic safety requirement be met. The
manufacturer cannot be held responsible for damages caused by the lack or inadequacy of an effective
grounding system.
Do not operate any appliance with a damaged power cord or power plug, and do not operate any appliance after
the appliance malfunctions or has been damaged in any manner. If this should occur, return the appliance to the
nearest authorized service facility for examination, repair or adjustment.
This appliance conforms to all uniform electrical safety codes and electrical grounding regulations. Install unit
according to I.A.W. local codes or with National Electrical Code ANSI/NFPA 70 or CSA C22.1 in their absence.