User Manual

First Time Assembly
First Time Start
Remove product from carton.
Assemble per instructions
in your operator’s manual.
1
WARNING: This Quick Start Guide is not a substitute for reading the
operator’s manual. To reduce the risk of injury, user must read and understand
operator’s manual before using this product.
2
3
Spread handle over power head
shaft and snap into place. Secure
with bolt and wing nut.
Snap shield into place over
shaft and bracket.
Secure with bolt as shown.
4
Align and assemble 2 shafts
until fully seated. Tighten
screws with provided hex key.
Mix 2.6 oz. 2-cycle oil with
1 gallon of fresh gasoline in
separate gas container. Shake,
then pour into trimmer tank.
5
6
7
7
Place trimmer on ground
with the trim head end facing
away from you.
Repeatedly press the primer
bulb 10 times.
Squeeze and hold trigger.
Pull quickly and powerfully
until engine attemps to
start (4x MAX.), then set
choke lever to HALF CHOKE
position.
9
8
Set choke lever to FULL
CHOKE position.
Pull quickly and powerfully
to start (6x MAX.)
Continue to squeeze and hold
trigger for 10 seconds after
engine starts. If engine
does not start,
REPEAT STEPS
11
12
Set choke lever to
RUN position.
You are now ready to Trim!
If engine did not start,
REPEAT STEPS
To stop trimmer, press the
red switch located on the
side of motor housing.
10X
TRIM!
10
10
995000938
8-5-19 (REV:01)
7
–
11
Go to www.blackmaxtools.com and register your new tool online.
For any questions about operating or maintaining your product,
call the BLACK MAX Help Line!
1-800-726-5760
Your product has been fully tested prior to shipment to ensure
your complete satisfaction. Troubleshooting tips are also
available in your operator’s manual.
For additional registration instruction, refer to operator’s manual.
CALL
1-800-726-5760
www.blackmaxtools.com