4 1 2 7 6 5 www.blackanddecker.com.au www.blackanddecker.co.
14 8 9a 6 12 11 9 A B H G 14 6 12 8a 11 16 8 7 C D 6 I J 14 5 11 5a 18 19 11 10 E 2 12 F K L 3
ENGLISH (Original instructions) (Original instructions) Intended use Your BLACK+DECKER BCG720 M1, BCG720 N angle grinder has been designed for grinding and cutting metal and masonry using the appropriate type of cutting or grinding disc when fitted with the appropriate guard. This tool is intended for consumer use only. Safety instructions General power tool safety warnings @ M Warning! Read all safety warnings and all instructions.
ENGLISH (Original instructions) at temperatures outside the specified range may damage the battery and increase the risk of fire. 6. Service a. Have your power tool serviced by a qualified repair person using only identical replacement parts. This will ensure that the safety of the power tool is maintained. b. Never service damaged battery packs. Service of battery packs should only be performed by the manufacturer or authorised service providers.
ENGLISH (Original instructions) Safety warnings specific for sanding operations u Do not use excessively oversized sanding disc paper. Follow manufacturers recommendations, when selecting sanding paper. Larger sanding paper extending beyond the sanding pad presents a laceration hazard and may cause snagging, tearing of the disc or kickback. Safety warnings specific for polishing operations u Do not allow any loose portion of the polishing bonnet or its attachment strings to spin freely.
ENGLISH u u u u u (Original instructions) in an air temperature below +4.5 °C), or above +40 °C. This is important and will prevent serious damage to the battery pack. The charger and battery pack may become warm to the touch while charging. This is a normal condition, and does not indicate a problem. To facilitate the cooling of the battery pack after use, avoid placing the charger or battery pack in a warm environment such as in a metal shed or an uninsulated trailer.
ENGLISH u u (Original instructions) Move the tool constantly in a straight line to prevent burning and swirling of work surface. Allowing the tool to rest on the work surface without moving, or moving the tool in a circular motion causes burning and swirling marks on the work surface. Remove the tool from work surface before turning tool off. Allow the tool to stop rotating before laying it down.
(Original instructions) ENGLISH (Original instructions) Sanding Flap Discs Type 27 guard Technical data Wire Wheels Type 27 guard Type 27 guard Type 27 guard BCG720 M1 BCG720 N 18 18 8600 8600 mm 22 22 Grinding discs mm 6.5 6.5 Cutting discs mm Input voltage VDC Rated speed (No load) min-1 Disc bore Max disc thickness Unthreaded backing flang 3.5 3.5 M14 M14 2.1 minus battery and Wheel 2.
Australia & New Zealand St Stanley Black & Decker www.blackanddecker.com.au www.blackanddecker.co.nz Tel.1800 338 002 (Aust) or Tel.