User's Manual

CHAPTER 17: Command Reference Guide
179
/L Log Functions
Provides access to a menu which allows you to display the Audit Log, Alarm Log
Current Metering Log and Power Metering Log. For more information on Log
Functions, please refer to Section 5.3.3 and Section 8.
Availability: Administrator, SuperUser
Format: /L [Enter]
/M Current Metering Status
Displays the Current Metering Status Screen, which lists current, voltage and power
readings, and also lists the trigger settings for the Over Temperature Alarm and the
Over Current Alarm. For more information on Current Metering, please refer to
Section 8.5. For more information on Alarm Conguration, please refer to Section 7.
Availability: Administrator, SuperUser
Format: /M [Enter]
/J Display Site ID / Unit Information
Displays the user-dened Site I.D. message. If the optional asterisk (*) argument is
included in the command line, the command will also show model numbers, current
ratings, and software versions for the Outlet Managed PDU.
Availability: Administrator, SuperUser, User, ViewOnly
Format: /J [*] [Enter]
Where * (asterisk) is an optional command argument, that is used to display the
model number, current rating and software version for the Outlet Managed PDU.
17.3.2. Control Commands
/X Exit Command Mode
When issued at the Network Port, also ends the Telnet session.
Note:
If the /X command is invoked from within a configuration menu,
recently defined parameters may not be saved. In order to make
certain that parameters are saved, always press the [Esc] key
to exit from all configuration menus and then wait until "Saving
Configuration" message has been displayed and the cursor has
returned to the command prompt before issuing the /X command.
Availability: Administrator, SuperUser, User, ViewOnly
Format: /X [Enter]