Instruction Manual

Bionix® Health at Home Ear Wax Removal Kit
Assembly Instructions
01. Open the box and remove 1 Three-Stream Tip, the Spray
Bottle and the Spray Head.
02. Hold the Spray Bottle firmly and fill it with warm water
(98
O
F – 104
O
F / 37
O
C – 40
O
C).
03. After filling, place the water reservoir on a secure, stable
platform.
04. Grab the head and guide the tube into the opening on the
Spray Bottle until fully inserted.
05. Point the head and wand in the same direction as the
larger end of the Spray Bottle base.
06. Secure the head with one hand and rotate the blue fasten-
ing ring at the base of the head clockwise until tight.
07. Take the Three-Stream Tip (as shown below) and twist
onto the luer lock fitting of the adapter until it stops.
Bionix® Health at Home Ear Wax Removal Kit
Use Instructions
01. Prime the unit by spraying water from the bottle into a
sink.
02. Insert the Three-Stream Tip fully into the ear canal and
place a basin beneath the outer ear to capture draining
water.
03. Spray water from the bottle to irrigate the ear and
repeatedly spray as needed.
04. When you are finished irrigating the ear, remove the Three-
Stream Tip from the ear and remove it from the adapter.
a. NOTE: Do not use the Three-Stream Tip on another
individual - the Three-Stream Tip is intended for single
person use only.
05. Remove a single blue Ear Drying Sponge from its package.
06. Insert one of the ends of the Ear Drying Sponge into the ear
and hold it in place for 10 seconds.
07. Remove the Ear Drying Sponge from the ear. If water is still
in the ear, rotate the Ear Drying Sponge and insert the dry
tip into the ear.
08. Hold the Ear Drying Sponge in the ear for 10 seconds.
09. Remove the Ear Drying Sponge from the ear and discard.
10. If water remains in the ear, repeat the process with a new
Ear Drying Sponge until the water is removed.
DRY
WET