SlimEdge Bidet Attachment User Manual
TABLE OF CONTENTS PRODUCT INFORMATION Features...............................................................................5 Parts.......................................................................................6 Dimensions.......................................................................7 PRODUCT INSTALLATION Pre-Installation..............................................................8 Installation........................................................................
FEATURES • Relax fit panel • Comfort grip control dial • High-quality ABS material with full body panel • Premium quality metal inlet and installation parts • Dual nozzle • Ambient temperature bidet wash • Adjustable water pressure • Unified internal brass valve • Durable braided metal cold water hose • No electricity or batteries required • Adjustable toilet fit • One-year warranty 5
PARTS DIMENSIONS Bidet attachment 15.5 in 8.66 in 4.33 in 5.51 in 2 Adjustable mounting brackets 12.3 in *T-Valve connector with rubber cone washer (7/8” x 7/8” x 3/8”) 12.4 in 27.5” Braided metal hose 2.44 in 3.66 in 2.48 in Teflon tape 0.236 in 2.76 in 2 Non-slip mats 3 Toilet bumpers *Alternate fittings available, contact support@biobidet.
PRE-INSTALLATION Please be advised that the provided T-Valve should be installed at the fill valve under the toilet tank, NOT down at the water supply coming from the wall. INSTALLATION 1. Remove the existing toilet seat by locating the bolts and nuts, typically under a plastic cover, and removing them first. 2. Close the water supply valve and flush the toilet completely so that there is little to no water left in the toilet tank. 3. Disconnect the water hose from underneath the toilet tank. 4.
INSTALLATION (CONT.) 5. Attach the water supply hose that comes from the water shut off to the bottom of the T-Valve. 6. Connect the metal hose we supplied to the open side of the T-Valve. 9. Place the bidet on the toilet with the mounting brackets over the bolt holes and make any needed adjustments to make sure the bidet is centered on the toilet. 10. Place the toilet seat back on the toilet over the bidet and secure the bolts down so that the seat and bidet attachment are stable. 7.
INSTALLATION (CONT.) HOW TO USE For back wash, turn the control knob to the left towards the “ “ position. For front/feminine, turn the control knob to the right towards the “ “ position. The further the knob is turned, the higher the water pressure will be. 13. After installing your bidet attachment, check to see if there is a gap between the toilet base and toilet seat. 14. If necessary, place the bumpers on the underside of your toilet seat as indicated above.
CLEANING Your SlimEdge is made with a high grade fire-retardant ABS resin. Using hard cleaning chemicals can weaken the material, causing it to damage and develop cracks. 1. Clean the SlimEdge by wiping the surface area with a damp cloth regularly. 2. Do not use harsh detergents or any cleaning tools with bristles on your bidet. Steam cleaning is the preferred cleaning method for your bidet. For a deep, chemical free clean, consider the BioMist Bidet Cleaner.
Thank You Technical Support/Customer Service 7900 S Route 31 Crystal Lake, IL 60014 T: 847.458.2334 U.S TOLL FREE: 877.339.5214 support@biobidet.com www.biobidet.
