User's Manual
Table Of Contents
- 1. Safety Instructions
- 2. Getting Started
- 2.1 Baby Unit Power Supply
- 2.2 Parent Unit Power Supply
- 2.3 Registration (Pairing)
- 3. Using the Baby Monitor
- 3.1 Setting up
- 3.2 Night Vision Mode
- 3.3 Talk Mode
- 3.4 Video ON/OFF
- 3.5 Temperature Display (HH °C / °F or LL °C / °F)
- 4. Parent Unit Menu Options
- 4.1 Volume
- 4.2 Brightness
- 4.3 Lullaby
- 4.4 Zoom
- 4.5 Alarm
- 4.6 Camera Control
- 4.6.1 Add (pair) a camera
- 4.6.2 View a camera
- 4.6.3 View multi-cameras on screen
- 4.6.4 Delete a camera
- 4.6.5 Scan camera
- 4.7 Temperature
- 4.8 Power Saving mode
- 5. Disposal of The Device (environment)
- 6. Cleaning
- 7. Help
- 8. General Information
10 Getting Started
4. If there is no connection or you are out of range, the video display will go
off and the unit will beep every 5 seconds. Move the parent unit closer to
the baby unit until the link is re-established.
5. Press and hold the
P POWER ON/OFF button, until the progress bar
finishes scrolling, to turn OFF the parent unit.
NOTE
The battery icon turns RED to indicate that the battery is low, and it gives
a beep every 16 seconds. The battery needs to be recharged. The battery pack
takes about 12 hours to charge fully.
When charging
1. During power OFF, when adapter is plugged in, a adapter logo will display
on screen and then a flashing battery logo will display for 45 sec.
2. During power ON, when adapter is plugged in, the battery icon on screen's
top right corner will show that the battery is charging.
2.3 Registration (Pairing)
The Baby monitor is pre-registered to your Parent Unit. You do not need to
register it again unless the Baby Unit loses its link with the Parent Unit.
To re-register your Baby Unit, or register a new Baby Unit, follow the procedure
below:
1. Press the
M button of the parent unit and the menu bar will pop up.
2. Press the
< LEFT button or > RIGHT button until is highlighted, and
the
del/add/view/scan
menu will pop up.
3. Press the
+ UP button or - DOWN button to select
add
, and press the OK
button to confirm.
4.
cam 1
/
cam 2
/
cam 3
/
cam 4
will pop up, press the + UP button or - DOWN
button to select the desired Camera and press the OK button to start
searching for a camera unit.
5. Press the OK button to confirm.
6. Press and hold the PAIR button on side of the baby unit until the parent unit
finds the camera, beeps and the video from the camera appears.
NOTE
If a particular Baby Unit was registered previously, registering this current
Baby Unit again will overwrite the old registration.