User's Manual

Getting Started 11
ENGLISH
1. Connect the micro USB plug of the power adapter to the Parent Unit and
the other end to a suitable mains power socket. Only use the enclosed
power adapter (5V DC / 1000mA) with the micro USB plug.
2. Press and hold the
0 POWER ON/OFF button for 3 seconds to turn ON
the Parent Unit.
3. Once the Baby and Parent Units are switched on, the display on the Parent
Unit will show the video captured by the Baby Unit.
4. If there is no connection or you are out of range, the unit will beep every
few seconds. Move the Parent Unit closer to the Baby Unit until the link is
re-established.
5. Press and hold the
0 POWER ON/OFF button, until the progress bar
finishes scrolling, to turn OFF the Parent Unit.
NOTE
The battery icon turns RED to indicate that the battery is low, and the
parent unit will beep every 15 seconds. The battery needs to be recharged; it
will take16 hours to charge fully.
When charging
1. If the Parent Unit is turned OFF with the adapter plugged in, a 2-pin plug logo
will appear on-screen for about 5 seconds, and then a flashing battery logo
will display for 15 seconds. The Blue LED at the top left will light up; indicating
that the adapter is plugged in and charging is continuing.
2. Whilst the power is ON, and the adapter is plugged in, the battery icon at
the top right corner of the screen will show that the battery is charging. The
Blue LED at the top left will light up to indicate that the adapter is plugged
in.