User's Manual
Table Of Contents
- 1. Safety Instructions
- 2. Getting Started
- 2.1 Baby Unit Power Supply
- 2.2 Parent Unit Battery Installation
- 2.3 Parent Unit Power Supply
- 2.4 Registration (Pairing)
- 3. Using the Baby Monitor
- 3.1 Setting up
- 3.2 Night Vision Mode
- 3.3 Video ON/OFF
- 3.4 Talk Mode
- 3.5 Touchless Thermometer
- 3.5.1 Forehead Temperature Mode
- 3.5.2 Object Temperature Mode
- 4. Parent Unit Menu Options
- 4.1 Volume
- 4.2 Brightness
- 4.3 Digital Pan and Tilt
- 4.4 Alarm
- 4.5 Camera Control
- 4.5.1 Add (pair) a camera
- 4.5.2 View a camera
- 4.5.3 Delete a camera
- 4.5.4 Scan the cameras
- 4.6 Body Temperature Measurement Review
- 4.7 Change of Measurement Scale
- 5. Disposal of The Device (environment)
- 6. Cleaning
- 7. Help
- 8. General Information
Getting Started 11
ENGLISH
2.4 Registration (Pairing)
The Baby Monitor Camera is pre-registered to your Parent Unit. You do not
need to register it again unless the Baby Unit loses its link with the Parent Unit.
To re-register your Baby Unit, or register a new Baby Unit, follow the procedure
below:
1. Press the
button of the Parent Unit and then press the - DOWN button
to select the Camera setting icon , and press the
button to enter.
Press the
- DOWN button to select ADD CAMERA icon , and press
the
button to confirm.
2.
1
/
2
/
3
/
4
will pop up, press the + UP button or - DOWN button to
select the desired Camera identification number and press the
button to
start searching for a Camera Unit. The Green Audio Level LED turns on will
appear while searching.
3. Press and hold the PAIR button under the bottom left edge of the Camera
Unit until the Parent Unit finds the Camera, beeps and the video from the
Camera appears.
NOTE
If a particular Baby Unit was registered previously, registering this current Baby
Unit again will overwrite the old registration.
If a Camera Unit is not found within about 30 seconds, the search will end and
the Parent Unit will return to its previous mode.