INSTALLATION Required Tools Required tools for installation. Please have these tools prepared prior to installation.
BEFORE YOU INSTALL Water pressure check, dimensional drawing. Checking your water supply The lowest working water pressure is 20.3 PSI, the highest water pressure is 108 PSI. If these conditions cannot be met, the bidet may not function as intended; the flush and bidet functions may not work properly. Confirm dimensions of product with installation space Wall Unit: inches 15.66 i T 26.92in n z apg] Side profile Front view Top view BidetMate.
INSTALLING YOUR PRODUCT Install your unit using the Following steps 1 Open the box right side up Remove the accessories first, then remove the unit from the top, as shown In the diagrams below. Smart Toilet Mark your drainage hole with a cross 1. Align the flange with the drain hole, and mark the positions of the four mounting holes of the flange on the ground with a marking pen. NOTE: If your existing toilet flange is still in good condition, you may not need to replace it. 2.
INSTALLATION CONTINUED Install your unit using the Following steps 4 Install the ceramic body, water supply hose and water filter 4, Wrap the T-valve’s threads with Teflon Plumber's Tape, attach the flush water hose to the T-valve, and tighten, 1. Place the wax ring on the drain hole at the bottom of the ceramic. Clean water hose T-valve tp ES Water supply 5. Wrap the T-valve’s threads with Teflon Plumber's Tape, 2.
INSTALLATION CONTINUED 5 Installing the remote 1.Drill two 6mm (1/4 inch) diameter holes on the wall 1.75" (1 3/4 inch) deep. 2. Hammer the anchors into the holes. . 3.Secure the holder with anchors. 4.Use the screws to secure the holder to the wall. 5.Remove the battery cover from the backside of the remote to install batteries 6.0nce finished, remote is ready to be placed in its holder.
INSTALLATION CONTINUED 1. Connact to the grounded outlet. | (1) Check to see if the power light 2.Plug in AC 120V power plug. is on. (2) Once the power light Is on, the taller will run lis Initial diagnostics: lights will tum on, cleaning nozzle will extend, the motor will begin to run and water will run through the system.Once the light is off, the self-diagnostic is complete. (3) Press the side knob to confirm that the toilet is powered on. 1.