INSTALLATION TOOLS NEEDED Adjustable Wrench (1.02in+ width) OR Open End Wrench A or PARTS INCLUDED Phillips @ Screw Driver rd Smart Bidet (1 set) Catch Plate (1 pc} Screw components (2 sets) Adjustment Plate Metal Washer g © Inflated tube T-valve (1 pc} > Hose (1 pc} Owner's Manual {1 pc} Fixed Card (1 pc} After opening the package, please confirm that you have received all parts listed above. IF you are missing any parts, please contact us.
BEFORE YOU INSTALL IMPORTANT! Before installing the product, please make sure that you meet all the requirements listed below. © The power rating should be within the required range (AC 120V + 10%, Max current 10A above) © The power outlet should be close enough to reach the power cord (47.24in) but far from where water can hit it. This product must be grounded. The wiring should be installed by a professionally licensed electrician.
INSTALLATION INSTALL R UNIT BY FOLLOWING ALL STEPS 1 Install the electronic bidet seat 1. Remove the existing toilet seat. (a) Remove the toilet seat mounting bolts. {b) Remove the existing toilet seat from the toilet. Existing seat Screw © Half spherical washer Twist to loosen 2, Insert the rubber anchors into the mounting holes on the toilet bowl. Mounting holes 3. Place the installation guide on the toilet bow! where the mounting holes are.
INSTALLATION ? Install the fleeter and hoses 1. Connect T-valve to tank. 2. Connect the hose to T-valve. Water tank inlet 3. Existing water pipe connect T-valve. 4, Connect the hose to bidet Existing water pipe 3 Turn on the water 4 Link the power 1. Turn the water back on by truing the knob on 1. Insert the bidet plug into the outlet (120V). the supply angle valve counter-clockwise until the valve is fully open. 2.
