User's Manual

3.6 LC-Display

1. “ERR“ Message: When the “ERR“ message is displayed, there is an error.

ERR noo3: The frequency you want to program is beyond the switching bandwidth of

the transmitter. Use a receiver with an appropriate frequency group. (At this time the

microphone is still operating and the frequency remains unchanged. To clear the

displayed “ERR“ message switch off the handheld transmitter and on again.)

ERR noo4: The frequency you want to program is beyond the switching bandwidth of

the transmitter. Use a receiver with an appropriate frequency group. (At this time the

microphone is still operating and the frequency remains unchanged. To clear the

displayed “ERR“ message switch off the handheld transmitter and on again.)

2. “Group“ & “Channel“: When both indications are displayed, it means that you are

using the pre-programmed frequency of the receiver.

3. “Channel“: If “Channel“ is displayed only, it means that you are using a frequency

which is not pre-programed.

3.7 Battery Status

• When the battery is exhausted, the LED (TS 900 C only) will illuminate. Replace the

battery. When “PoFF“ is displayed, the transmitter is switched off to avoid an over-

discharge of the battery.

3.8 How to switch off the Beltpack Transmitter

When the ON/OFF switch is switched to “OFF“, at first “PoFF“ is displayed and as soon

as the transmitter is completey off the display is blank. Wait one second if you want to

switch on the transmitter again immediately.

Opus900_BA_DEF_neu:Opus900_BA_DEF 26.09.2006 14:48 Uhr Seite 64