Installation Guide

1. Place the mirror in the desired location on the wall. Mark a line on the wall at the top-
center of the mirror (two people are required for this step). Carefully set the mirror
aside when complete.
2. Position the Wall Bracket so that the top of the bracket is 3” below the Top of Mirror
Line from step #1. Use a level to ensure the Wall Bracket is level, then mark the
positions of the Wall Bracket Screw Holes.
Note: The ridges on the Wall Bracket should be against the wall and the screw holes
should be on the bottom. See illustrations.
3. Using a ¼-inch bit, drill pilot holes into the marked locations. Insert the provided
anchors until flush with the wall surface. Place the Wall Bracket onto the wall and
secure with the provided screws.
4. Apply two rubber bumpers near the bottom corners of the back of the mirror.
5. Carefully hang the mirror by placing the Mirror Mounting Plate onto the Wall Bracket.
Positioning can be adjusted side to side by gently sliding the mirror along the
bracket.
Installation Guide
ILLUSTRATION
Mirror
Outline
Top of Mirror Line
(Step #1)
3”
(Step #2)
(see reverse)
Wall Bracket Screw Holes