Installation Guide

1. Place the mirror in the desired location on the wall. Mark a line on
the wall at the top-center of the mirror (two people are required for
this step). Carefully set the mirror aside when complete.
2. Position the Wall Bracket on the wall so that the top of the bracket is
4-1/2” below the Top of Mirror Line from step #1. Use a level to
ensure the Wall Bracket is level, then mark the positions of the Wall
Bracket Screw Holes. See illustration below.
Note: When positioned on the wall, the Wall Bracket Screw Holes
should be on the bottom of the bracket. See reverse for illustration.
3. Using a ¼-inch bit, drill pilot holes into the marked locations. Insert
the provided anchors until flush with the wall surface. Place the
Wall Bracket onto the wall and secure with the provided screws.
4. Apply two rubber bumpers near the bottom edge of the back of the
mirror. For framed mirrors, bumpers are not necessary.
5. Carefully hang the mirror by placing the Mirror Mounting Plate onto
the Wall Bracket. Positioning can be adjusted side to side by gently
sliding the mirror along the bracket.
Installation Guide
ILLUSTRATION
Mirror
Outline on
Wall
Top of Mirror Line
(Step #1)
4-1/2”
(Step #2)
Wall Bracket Screw Holes