Installation Guide

5
3.2 FOR 30” WIDE HOODS:
Remove the 7 screws (A only) retaining the bottom panel, and set aside.
FOR 36” WIDE HOODS:
Remove the 8 screws (A and B) retaining the bottom panel and set aside.
HO0246
A
B
3. PREPARE THE HOOD (CONT'D)
3.3 Using both hands, gently pull on the blower wheel to remove. Set blower wheel
aside.
HO0347
4.1 Carefully remove glass panel from its packaging.
Remove glass panel nuts (factory installed) from both studs and set aside.
4.2 Insert glass panel studs in hood front holes.
4.3 While holding glass panel, pre-tighten previously removed nuts by hand. Ensure glass panel is flush with top of hood and centered
from side-to-side.
Then, using a 3/8" socket, tighten nuts completely.
4. INSTALL GLASS PANEL (SBN MODELS ONLY)
The SBN hood models decorative glass panel is sold separately and has to be installed before completing the hood installation.
HD0556
NUT
STUD