Installation Parts Guide

Cattura Downdraft Installation Parts Guide (Revision February 2020)
1
Accessories for all Applications
• ACRD/ACRDBLS: Remote Up/Down control Stainless Steel/ Black Stainless (optional).
• AEWD5: 5’ Ext. cable for electrical panel. Only required if electrical panel is more than
two feet away from downdraft. Use up to 2 extension cables connected together.
• ATTD1/ATTD1BLS: End Cap trim extension to expand 1” overall trim width. Includes Left &
Right trim caps Stainless Steel/ Black Stainless (optional).
• ATSKD30, 36, 48: Gas cooktop seal kit. Use if a gas cooktop is installed.
• MD6T, MD8T, and MD10T: 6”, 8” and 10” make-up air damper.
• 641FA, 643FA, and 610FA; 6”, 8” and 10” Fresh Air inlets for use with make-up air
damper
Note:
- For Range Top applications that are 48” or with grill, recommend Option 3 with EB15.
- For Slide-in Range applications with grill, recommend Option 9 using dual outlet with
EB15.
Option
FRONT Installation
Parts needed
1
Front / Internal / In Cabinet
Ref. Page 8 spec sheet
D49M (30-36-48)
PF6 - Internal blower
408 – 8” Rd Duct / 432 - 8” Elbow (as required) /643 - 8’’ Rd wall cap
ANKD – Recirculation kit (optional)
2
Front / Internal / Under Floor
Ref. Page 9 spec sheet
D49M (30-36-48)
PF6 - Internal blower
ACVPD8 – Front panel rough-in plate 8’’ round
408 – 8” Rd Duct / 432 - 8” Elbow (as required) /643 8’’ Rd wall cap
3
Front / Exterior or In-Line
Ref. Page 13 spec sheet
D49M (30-36-48)
EB9, EB12, EB15, ILB11 – Exterior or in-line blower
ACVPD10 - Front panel rough-in plate 10’’ round
410 – 10” Rd Duct / 418 - 10” Elbow (as required) /
441 - 10’’ Rd wall cap (if ILB11 in-line blower is used)