Installation Guide

Page 7
Models D49M30SB • D49M36SB • D49M48SB
INSTALL DUCTWORK
1. Cut hole in cabinet as well as holes in wall or floor as necessary.
2. Mount the roof or wall cap and work back towards the cabinet,
attaching all ductwork, elbows and transitions as previously
planned. Tape all ductwork connections to make them secure
and air tight.
3. Connect ductwork (and transition, if required) to downdraft.
!
CAUTION: BEFORE CUTTING HOLE IN CABINET
FOR DUCTWORK, check for interference with floor
joists, wall studs, electrical wiring, or plumbing.
INSTALL FINISH TRIM
1. Remove TAPE BACKING.
2. WIPE SURFACES CLEAN on underside of right trim - so tape
adhesive will stick tightly.
TAPE
BACKING
WIPE
SURFACES
CLEAN
TOP
DOOR
TOP
DOOR
RIGHT
TRIM
WASHER
FLUSH
1/16" GAP
3. Press RIGHT TRIM in place.
Make sure trim:
• sits flat on countertop surface.
• is flush with TOP DOOR.
• has 1/16" GAP between trim and top door.
• wiring is not pinched.
4. Repeat Steps 1, 2 & 3 to install left trim.
TOP VIEW