Installation Guide

Page 10
Models D49M30SB • D49M36SB • D49M48SB
INSTALL COOKING APPLIANCE
1. Align the cooking appliance with downdraft and fasten appliance
in place following appliance instructions.
Note: Accurate alignment of cooking appliance and downdraft is
necessary to ensure that there is no interference when air vent is
raised and lowered. There should be a gap of 1/32" - 1/16" between
the back of the cooktop and the front of the downdraft cover.
OPTIONAL
ACCESSORY
DESCRIPTION /
APPLICATION
MODEL ATTD1
END CAP TRIM EXTENSION
+1" WIDTH - LH & RH
Use left and right to increase the
overall trim width by 1" - to 31", 37"
and 49".
MODEL ACVPD8
FRONT PANEL ROUGH-IN PLATE -
8" ROUND
Use where 8" round duct or elbow
attaches to front of airbox (Model PF6
remote blower installation).
MODEL ACVPD10
FRONT PANEL ROUGH-IN PLATE -
10" ROUND
Use where 10" round duct or elbow
attaches to front of airbox (exterior or
in-line blower installation).
MODEL 432 - 8" RD.
MODEL 418 - 10" RD.
90
0
DUCTWORK ELBOW
Adjustable from straight to 90
0
.
Galvanized steel construction.
MODEL 408 - 8" RD.
MODEL 410 - 10" RD.
STRAIGHT ROUND DUCT - 2-FT.
Galvanized steel construction.
MODEL AEDD2
RECTANGULAR DUCT - 2-FT.
SECTIONS (1-7/8" X 19")
Galvanized steel construction.
OPTIONAL ACCESSORIES
(CONTINUED)
OPTIONAL
ACCESSORY
DESCRIPTION /
APPLICATION
MODEL AVDKD8810
TRANSITION "Y"
(2) - 8” ROUND TO (1) - 10” ROUND
Galvanized steel construction.