User's Manual

SmarTire Systems Inc.
Tire Monitor System Owner’s Manual
Draft
2/25/2003 Page 7
This manual is under review by SmarTire
Installing Transmitter on a Wheel
Shorten the strap by cutting to the appropriate length for the wheel diameter used (see chart). Remove burrs from
strap end.
Wheel diameter 13 14 15 16 17 18 19 20
Cut-off length 21” 18” 15” 12” 9” 6” 3” 0”
Select a transmitter for a corresponding wheel location
(see chart). Pass strap through transmitter as shown.
Color Wheel Position
Green Right front
Red Left front
Blue Right rear
Yellow Left rear
The base of the drop centre well must be flat and wide
enough to allow the transmitter to contact the rim over
its complete width.
• Position the transmitter in the lowest area of the
drop centre well near the valve.
• Attach the strap end to the clamp by advancing
the wormgear with the socket driver. Tighten
to 30 inch pounds.
• Cut off excess strap length to approximately
one inch from the wormgear.
Attach the appropriate color of washer on the valve stem
as shown.
Proceed to mount the tire on the wheel.