SWING Technical and Installation www.belldinni.
SWING INSTRUCTIONS 1. MEASUREMENT OF THE OPENING Y X X Rough opening Door slab size: Minimum width X-2” Recommended width X-2,5” Minimum height Y-2” from the finish floor Recommended height X-2,5” from the finish floor Y 2. PACKING AND IDENTIFYNG FRAMS AND CASINGS SET Packing and identifying frames and casings set 3.
4. CUTTING HEADER TO THE SIZE OF THE DOOR Jumb - H1=H+(27-47) (Н+(1 1/16"-1 7/8") Header – B1 = B+44 (B+1 3/4”) 5. ASSEMBLING THE SINGLE SWING DOOR KNOCK DOWN SET Drill holes with a diameter of 5/64x6/64". Tighten with 1/4x2" screws. 6. ASSEMBLING THE SINGLE SWING DOOR KNOCK DOWN SET Door frame should be put into the opening. It is fixated with wooden wedges. Be sure to use pair wedges, setting them opposite to each other.
8. USING THE DOOR FOAM Using the door foam (Use HILTI CF 812 door foam recommended to use (not provided)) Wait until it dries and cut off excess foam 9. INSTALLATION OF THE INSIDE CASING (DOOR MOLDING) Mark the length needed, trim. a. Place casing vertical along the jamb and place a header vertical to the frame header b. Mark on the vertical casing where the top of the horizontal casing ends c. Cut the moldings and do the same things for the other side d.
(908) 888-6802
