| / Bella Depot Retractable Ceiling Fan Installation & Troubleshooting Manual CAUTION READ INSTRUCTIONS CAREFULLY FOR SAFE INSTALLATION AND FAN OPERATION
Installation & Troubleshooting Manual For Bella Depot Ceiling Fan SAFETY RULES 10. 1. To reduce the risk of electric shock, tum off the electricity to the fan at the main fuse box or circuit panel before beginning. All wiring must be in accordance with the local electrical codes or National Electrical Code. Electrical installation should be performed by a qualified licensed electrician. To avoid personal injury, the use of gloves may be necessary while handling fan parts with sharp edges.
Installation & Troubleshooting Manual For Bella Depot Ceiling Fan Unpack your fan and check the contents. You should have followings: BEFORE INSTALLATION 1. Mounting Bracket X 1 2. Canopy Screws X 2 3. Canopy X 1 4. Down rod & Hanger Ball X 1 5. Lock Pin X 1 &, Mitch Pin X 1 .'Coupling Cover X 1 Motor X 1 . Fgh Blades 10. Light & Driver X 1 11. Lamp Shade X 1 12. Remote Receiver X 1 13. Remote Controller X 1 14. Screw & "J" hook X 1 15. Safety Cable X 1 16. Wood Screws X 4 17. Expansion Screws X 2 www.
Installation & Troubleshooting Manual For Bella Depot Ceiling Fan INSTALL THE FAN Tools Required: Phillips Screwdriver, Pair of Pliers, Straight slot screwdriver, Adjustable Wrench, Step Ladder and Wire Cutters. INSTALL THE MOUNTING BRACKET To prevent personal injury and damage, ensure that the hanging location allows the blade a clearance 7 feet (2.13 meters) from the floor and 18 inches {45.72 centimeters) from any wall or obstruction.
Installation & Troubleshooting Manual For Bella Depot Ceiling Fan INSTALL THE DOWN ROD REMEMBER to turn off the power. Follow the steps below to hang your fan properly: 1. Remove the lock pink and hitch pin from down rod 2. Place down rod assembly into canopy and coupling cover, carefully feed motor wires through the down rod assembly 3. Loosen the two set screws in down rod coupling 4. Insert down rod into down rod coupling. Install coupling lock pin through coupling and down rod.
Installation & Troubleshooting Manual For Bella Depot Ceiling Fan WIRING WITH REMOTE RECEIVER From House From Fon Make wiring connections from the house and the Red : 3 Bock _Re Roadblock Black motor to the remote receiver as shown right. Connect | — using wire nuts (provided). Blue Blue non EN White Once wiring step has been completed, slide the wired remote receiver in between the mounting bracket and the top of the down rod ball.
Installation & Troubleshooting Manual For Bella Depot Ceiling Fan INSTALL DECORATIVE SHADE Put the shade into the light plate and twist it it. Ensure the shade is tightening firmly, the shade will drop off and broken not installed properly. www.BellaDepot.com © 2020 Bella Depot Inc.
Installation & Troubleshooting Manual For Bella Depot Ceiling Fan INSTALL WALL SWITCHES (OPTIONAL) BEFORE: 1. This is LED ceiling fan, it can't be gradually dimmed, DO NOT use any Dimmer Switch for this. 2. Install & Control the ceiling fan via remote OR wall switch, Please DO NOT install both of them since the wiring is complex depend on the different switch you use, and it may interfere with the remote/receiver signal and the fan/light fixture will not work properly.
Installation & Troubleshooting Manual For Bella Depot Ceiling Fan CCT Dilemma Light Operation If your ceiling fan is CCT dilemma light, it has 3 light tones, please tum off the light then tum it on again, the light tons will change. TROUBLESHOOTING GUIDE If you have difficulty operating your new ceiling fan, it may be the result of incorrect assembly, installation, or wiring. In some cases, these installation errors may be mistaken for defects.
Installation & Troubleshooting Manual For Bella Depot Ceiling Fan Problem: Fan & Light do not work / Remote control malfunction i Solution: Test the Fan and LED Lights -Without the Remote & transmitter In most cases, the ceiling fan & light don t work because of the wrong programming of the Remote Control, please try| to connect the wiring without the Remote & transmitter: (Tum off the main power: a) Connect the wiring at the bottom for the LED Light b) Connect the Ceiling Fan Neutral Wire (White) to the Ne