Users Manual

PCB Antenna with antenna gain ‐1dBi

We will retain control over the final installation of the module such that compliance of the end

product is assured. In such cases, an operating condition on the limit module approval for the

module must be only approved for use when installed in devices produced by a specific

manufacturer. If any hardware modify or RF control software modify will be made by host

manufacturer, C2PC or new certificate should be apply to get approval, if those change and

modification made by host manufacturer not expressly approved by the p arty responsible for

compliance, then it is illegal.

FCC Radiation Exposure Statement

The module can be installed or integrated in mobile or fix devices only. This module cannot be

installed in any portable device. This modular complies with FCC RF radiation exposure limits set

forth for an uncontrolled environment. This transmitter must not be co‐located or operating in

conjunction with any other antenna or transmitter. This module must be installed and operated

with a minimum distance of 20 cm between the radiator and user body.

f the FCC identification number is not visible when the module is installed inside another device,

then the outside of the device into which the module is installed must also display a label

referring to the enclosed module. This exterior label can use wording such as the following:

“Contains Transmitter Module FCC ID: 2AQ95‐C22H Or Contains FCC ID: 2AQ95‐C22H”

OEM INTEGRATION INSTRUCTIONS:

This device is intended only for OEM integrator under the following conditions:

The module must be installed in the host equipment such that 20 cm is maintained between the

antenna and users, and the transmitter module may not be co‐located with any other

transmitter or antenna. The module shall be only used with the internal on‐board antenna that

has been originally tested and certified with this module. External antennas are not supported.

As long as these 3 conditions above are met, further transmitter test will not be required.

However, the OEM integrator is still responsible for testing their end‐product for any additional

compliance requirements required with this module installed (for example, digital device

emissions, PC peripheral requirements, etc.). The end‐product may need Verification testing,

Declaration of Conformity testing, a Permissive Class II Change or new Certification. Please

involve a FCC certification specialist in order to determine what will be exactly applicable for the

end‐product.

Validity of using the module certification:

In the event that these con dition s cannot be met (for examp l e certain la pt op configurat ions or

co‐location with another transmitter), then the FCC authorization for this module in combination

with the host equipment is no longer considered valid and the FCC ID of the module cannot be

used on the final product. In these circumstances, the OEM integrator will be responsible for

re‐evaluating the end product (including the transmitter) and obtaining a separate FCC

authorization. In such cases, please involve a FCC certification specialist in order to determine if a

Permissive Class II Change or new Certification is required.

Upgrade Firmware:

The software provided for firmware upgrade will not be capable to affect any RF parameters as

certified for the FCC for this module, in order to prevent compliance issues.

End product labeling:

This transmitter module is authorized only for use in device where the antenna may be installed