User's Manual

BEIJING JIA AN ELECTRONICS TECHNOLOGY CO.,LTD. AN2640SA-B Module Datasheet V1.0
http://www.rf-products.com Oct 28th 2015
Page 5 of 5
The AN2640SA-B module is designed to comply with the FCC statement. FCC ID is VVJ-AN264
0SA-B. The host system using AN2640SA-B, should have label indicated FCC ID VVJ-AN2640S
A-B.
This radio should NOT be installed and operating simultaneously with other radio
FCC STATEMENT
§ 15.21 Information to user.
Any Changes or modifications not expressly approved by the party responsible for compliance co
uld void the user's authority to operate the equipment.
§ 15.105 Information to the user.
Note: This equipment has been tested and found to comply with the limits for a Class B digital dev
ice, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protecti
on against harmful interference in a residential installation. This equipment generates uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that inte
rference will not occur in a particular installation. If this equipment does cause harmful interferenc
e to radio or television reception, which can be determined by turning the equipment off and on, th
e user is encouraged to try to correct the interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is conn
ected.
-Consult the dealer or an experienced radio/TV technician for help.
*RF warning for Mobile device:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environ
ment. This equipment should be installed and operated with minimum distance 20cm between the
radiator & your body.
§ 15.19 Labelling requirements.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.