User Manual
Table Of Contents
- Rider's manual S 1000 RR
- General instructions
- General views
- Status indicators
- Operation
- Ignition switch/steering lock
- Emergency off switch (kill switch)
- Intelligent emergency call
- Lights
- Hazard warning lights system
- Turn indicators
- Dynamic Traction Control (DTC)
- Riding mode
- Cruise-control system
- Hill Start Control
- Gearshift light
- Anti-theft alarm (DWA)
- Tyre pressure monitoring (RDC)
- Heated handlebar grips
- On-board computer
- Front and rear seats
- TFT display
- Adjustment
- Riding
- On the race track
- Displays for racing
- LAPTIMER
- Vehicle settings for racing
- RACE PRO riding modes
- Launch Control
- Pit Lane Limiter
- DTC
- Chassis and suspension settings for racing
- Removing and installing mirrors
- Removing and installing number-plate carrier
- Switching off ABS when riding on the race track
- Deactivating intelligent emergency call when riding on the race track
- Gearshift-pattern reverser
- Engineering details
- Maintenance
- Accessories
- Care
- Technical data
- Service
- Appendix
- Index
making changes, the clearance
to the rear wheel swinging arm
and rear wheel must always be
checked.
Additional tools such as an
engine lifter or footrest stand
are required for adjusting the
riding height; however, they
will not be dealt with in detail
here. If you are in doubt as to
whether you would be able to
complete this work, contact a
specialist workshop, preferably a
BMW Motorrad Retailer.
Adjusting riding height at
the traction strut
Place the motorcycle on its
stand on firm, even ground.
Lift motorcycle with engine
lifter, so that there is no load
on the rear wheel swinging
arm.
Secure the motorcycle against
falling over.
Loosen clamping bolts 1.
To increase the riding height,
turn the adjusting screw 2 in
the direction A.
To reduce the riding height,
turn the adjusting screw 2 in
the direction B.
Traction strut length
87.5 mm (Basic setting)
86...91 mm (Adjustment
range)
Adjust riding height to the
swinging arm pivot point
setting:
Measure and adjust gap di-
mension D at traction strut 1.
Traction strut gap di-
mension to compensate
the swinging arm pivot point
setting
9.5 mm (Basic setting)
12.5 mm (Position 2)
13 mm (Position 3)
Tighten the clamping bolts 1.
Clamping bolt at adjust-
ing strut
8 Nm
6
115
z
Adjustment