Manualshelf

User Manual

ManualsBrandsBeagleBoard Manuals32 Bit MicrocontrollersBeagleBoard BeagleBone Black Development Platform
21222324252627282930
element14 is a trademark of Premier Farnell plc 22
© 2014 Premier Farnell plc. All Rights Reserved
Figure 14 Connect microHDMI Cable to the Board
The connector is fairly robust, but we suggest that you not use the cable as a leash for
your Beagle. Take proper care not to put too much stress on the connector or cable.
6. Booting the Board
As soon as the power is applied to the board, it will start the booting up process.
When the board starts to boot the LEDs will come on in sequence as shown in
Figure
15
below. It will take a few seconds for the status LEDs to come on, so be patient.
The LEDs will be flashing in an erratic manner as it boots the Linux kernel.
Figure 15 Board Boot Status