Assembly Instructions

PB
4
FRONT
BACK
5:
Insert the Glass (Q) at an angle and fit
glass pucks into designated holes on Desk
Frame (R).
7:
Remove Adhesive Foam/Magnets from
the Upper Beam (M). Peel film from side
of the Adhesive Foam/Magnets and attach
to clean, dry back side of AC power strip
(not included). Cleaning of power strip
surface with rubbing alcohol will ensure
best adhesive bond. **UNPLUG POWER
STRIP FROM POWER SOURCE BEFORE
CLEANING**Attach AC power strip/surge
protector to inside of Upper Beam (M).
8:
Use the slot holes provided to run all
wires to and from the desk. Keep all wires
behind folded metal lip—failure to do so
will prevent Kick Panel (P) from attaching
properly. Once all of the electrical wires
are routed, install Kick Panel (P) as shown
below. The rear side of panel has magnets
that will hold the panel in place. Note:
The Inline Desk is designed to permit
placement in front of an electrical outlet
for easier wiring access.
6:
Q
* AC Power Strip Not Included
2.
3.
1.
O
P