Installation & Assembly_2

ManualsBrandsBDI ManualsDesksCascadia Desk

C - 1/4-20 x 12mm Screws

4mm Socket Drive

x 4

A - 4mm Hex Driver x 1

B - 5/16-18 x 50mm Screws

4mm Socket Drive

6201 x 8

6202 x 6

CASCADIA

These distinctive product configurations are protected by US and international

patents, trade dress, and/or copyright laws.

BDI are trademarks of Becker Designed, Inc.

6 BDI

6201 6202 Revision: 05-05-16

Component List

CASCADIA are engineered for easy assembly. Carefully follow this procedure to prevent any damage.

Unpack and identify the components. The assembly workspace should be a non-marring surface such as clean carpet.

For missing hardware pieces, please contact BDI Customer Service at customerservice@bdiusa.com.

For all other concerns, please contact your BDI Retailer.

6201 6202

ASSEMBLY INSTRUCTIONS

BDIUSA.COM CUSTOMERSERVICE@BDIUSA.COM

Placement and Maintenance

CASCADIA is designed for indoor use on level floors.

D - Table Assembly x 1

E - Left Leg x 1

F - Right Leg x 1

G - Horizontal Bar x 1

CASCADIA 6201 Desk

CASCADIA 6202 Console

Summary of content (4 pages)

PAGE 1
ASSEMBLY INSTRUCTIONS CASCADIA 6201 6202 BDIUSA.COM CUSTOMERSERVICE@BDIUSA.COM Placement and Maintenance CASCADIA is designed for indoor use on level floors. CASCADIA 6201 Desk CASCADIA 6202 Console Component List CASCADIA are engineered for easy assembly. Carefully follow this procedure to prevent any damage. Unpack and identify the components. The assembly workspace should be a non-marring surface such as clean carpet.
PAGE 2
Step 1 Attach 1st Leg to Table Assembly Identify Left and Right Legs. Notch on Leg towards inside and back of desk. Attach Leg using Screws (B) and tighten with Hex Driver (A). E A E B B D E D Identify Left and Right Legs. Notch on Leg towards inside and back of desk. D Step 2 Attach Horizontal Bar Insert tab on Horizontal Bar (G) into notch on inside of Leg. Attach 1 side of Horizontal Bar (G) using Screws (C) tighten with Hex Driver (A).
PAGE 3
Step 3 Attach 2nd Leg and Horizontal Bar Insert tab on Horizontal Bar (G) into notch on 2nd Leg. Attach Leg to Table Assembly (D) using Screws (B) and tighten with Hex Driver (A). Attach Horizontal Bar (G) to 2nd Leg using Screws (C) and tighten with Hex Driver (A). A F B F F B G C D A Step 4 Adjust Levelers as necessary Turn Desk or Console over onto Legs. Position Desk or Console as desired then turn black puck levelers by hand to adjust as necessary.
PAGE 4
Step 5 (6201 optional) Change Drawer Positions Place Desk or Console upside down on clean carpet. Remove both drawers. Fully extend drawers, then press on release tabs to release drawer from slides. Remove screws from drawer slide block using Hex Driver (A). A Recommended 2-person Step D Step 6 (6201 optional) Change Drawer Positions Move drawer slide block over to other position and align screws with inserts. Attach drawer slide block to Table Assembly (D) and tighten screws using Hex Driver (A).