Instructions / Assembly

1. Open tank cylinder control valve by turning it to OPEN
Direction (Figure 1).
2. To start timer operation, push the black “POWER”
button. Both lights will blink once. Press red “START”
button. The green light will remain on. The timer is now
set for a 15 minute operational cycle. NOTE: Gas
will NOT flow to the burner unless the timer is turned
on.
3. Insert a multipurpose lighter below the windscreen,
to the edge of the burner, or use a long fireplace
match placed above the burner. Turn the regulator
control toward the “ON” position until ignition
occurs (Figure 2). Turning the regulator control
toward the “ON” direction increases the gas
pressure to the burner and hence the flame size.
When lighting the appliance, if ignition does
not occur in 3 to 5 seconds, turn the regulator
and cylinder valve off. Wait 5 minutes for gas
to disperse. Repeat procedure.
4. Always monitor the flame throughout the cooking
process. If at any point in the cooking process the
flame is accidentally extinguished, immediately turn the
regulator and cylinder valve OFF. Wait 5 minutes for
gas to disperse and relight the cooker according to the
directions in this section.
12
START Button
POWER Button
LOW BATTERY
Light
GAS FLOW
Light
LIGHTING AND OPERATING INSTRUCTIONS
IMPORTANT: The Cooker must not be lit until the preceding placement instructions have been
completely followed. (Illustrations page 10)
Figure 2
Figure 1