Owner`s manual

153
+------+------------------+
| 1 | 01:03,1 |
+------+------------------+
Disable Port I.D..........................1
Use Unit,Module,Port number...............2
Use Device Name...........................3
Select Port I.D (ENTER = no change):
Type "1" to disable the Port ID feature, "2" to send the
selected port's Unit Number:Module Number,Port
Number as the Port ID, or "3" to send the selected
port's device name as the Port ID.
16.6V50/V73/V74/V75/V76/V86/V87
DESIGNATE HOST MODULE LOCATION
By responding to the Enter Request: message at the
end of the configuration menu (see Section 16.1) with
"5" (Designate Host Module Location), you can program
the unit number, module number, and port number of
the host module to which the module sends completed
messages in immediate reporting mode. This option is
typically used when multiple host modules are installed
in the base unit and/or when using cascaded units. The
module will respond with:
Current Host Designation is Module........1:1,1
Enter New Host Unit Number (1-30):
Type the desired unit number followed by <ENTER>.
The module will respond with:
Enter New Host Module Number (1 to 16):
Type the desired module number followed by <ENTER>.
NOTE: If you type "0" from this menu, all completed
messages are sent to the base unit (i.e., the service
port or service modem).