Electric Fireplace Model# EF-30F（95139） CONSUMER SAFETY INFORMATION ⚫ Read this manual before installing and operating this appliance ⚫ Failure to follow these instructions may result in electric shock, fire property, or personal injury ⚫ Do not store or use gasoline or other flammable liquids in vicinity of this appliance.
IMPORTANT SAFETY INFORMATION! WARNING ⚫ ALWAYS keep electric cords, home furnishings, drapes, clothing, papers, or other combustibles at least 3 feet (0.9m) away from the front of this heater, and away from the bottom, sides, and rear of this heater. ⚫ DO NOT place the heater near a bed because objects such as pillows or blankets can fall off the bed and be ignited by the heater. ⚫ DO NOT COVER this heater or block the air vents at all. Doing so could cause a fire.
WARNING ⚫ Risk of electric shock! DO NOT OPEN! No user-serviceable parts inside! ⚫ ALWAYS disconnect this unit from the power supply before performing any assembly or cleaning, or before relocating the electric fireplace. ⚫ ALWAYS store this heater in a dry location. NEVER use the fireplace if it has become wet. ⚫ NEVER use this heater in bathrooms, laundry rooms, or any other location where the heater could fall into a bathtub or pool, become damp or come in contact with water.
PREPARATION This insert has front panel made of GLASS! ALWAYS use extreme caution when handling glass. Failure to do so could result in personal injury or property damage. Remove all parts and hardware from the carton and place them on a clean, soft, dry surface. Check the parts list to make sure nothing is missing. Dispose of packaging materials properly. Please recycle whenever possible.
REMOTE CONTROL The remote control operates with one 3V CR2025 Lithium Cell Battery (included). Remove the protective sheet between the battery and the contacts in order to operate (see Page 7). ALWAYS unplug this fireplace heater before assembly or cleaning, or before relocating. Failure to do so could result in electric shock, fire, or personal injury. Remote Control Set-up ⚫ Fig. 1: Remove the plastic sheet from the end of the remote control to allow the battery to touch the electrical contacts.
Power Make sure the ON/OFF switch, located on the control panel, is in the OFF position. Plug the power cord into a 110~120 Volt 15 Amp grounded outlet (see IMPORTANT SAFETY INFORMATION on Pages 3 and 4). Make sure the outlet is in good condition and that the plug is not loose. NEVER exceed the maximum amperage for the circuit. DO NOT plug other appliances into the same circuit. Methods of Operation CONTROL PANEL: Controls ON/OFF, DIMMER, and HEATER. REMOTE CONTROL: Controls ON/OFF, HEATER, and DIMMER.
Flame effect must be ON for heater to function. 1. Press once for low heat (750W). 2. Press again for high heat (1500W). 3. Press again to turn off heater. 1. Heater & fan turn on low (750W). Indicator light turns on. Warm air blows. 2. Heater & fan turn on high (1500W). Indicator light turns on. Hot air blows. 3. Heater turns off. Fans may blow air after heater is turned off to cool down. Adjust the heater To set the temperature button to select the desired temperature.
FCC STATEMENT Remote Control FCC Information NOTE: This equipment has been tested and found to comply with the limits for Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
Metal: ⚫ Buff using a soft cloth, slightly dampened with a citrus oil-based product. ⚫ DO NOT use brass polish or household cleaners as these products will damage the metal trim. Glass: • Use a good quality glass cleaner and dry thoroughly with a paper towel or lint-free cloth. • NEVER use abrasive cleansers, liquid sprays, or any cleaner that could scratch the surface. Vents: • Use a vacuum or duster to remove dust and dirt from the heater and vent areas.
TROUBLESHOOTING WARNING: Turn off the appliance, unplug and let cool for at least 10 minutes before attempting to service. Only a qualified professional should attempt to service or repair the appliance. Problem Possible Cause 1. Dimmer control button set too Low. 2. LED bulb are burned out. 3. “Flame wand” has come loose from bracket. 4. “Flame wand” motor is not functioning. The appliance turns off and will 1.The overheat protection device in not turn back on the appliance has been triggered. 2.
