Instructions / Assembly

ManualsBrandsBarrette Outdoor Living ManualsFencing2 in. x 2 in. Black Aluminum Pyramid Post Top

ALUMINUM PRE-BUILT FENCE

STANDARD & HEAVY-DUTY SERIES

WEB REV 11.20

Read all instructions prior to installing product.

Refer to manufacturers safety instructions when operating any tools.

To register your product, please visit: barretteoutdoorliving.com

Installation Instructions

Summary of content (6 pages)

PAGE 1
WEB REV 11.20 ALUMINUM PRE-BUILT FENCE STANDARD & HEAVY-DUTY SERIES Installation Instructions Read all instructions prior to installing product. Refer to manufacturers safety instructions when operating any tools. To register your product, please visit: barretteoutdoorliving.
PAGE 2
WARNING: • Improper installation of this product can result in personal injury. Always wear safety goggles when cutting, drilling and assembling the product. • Incorrect installation may cause harm to the product or individual. • Not pool code approved. NOTICE: • DO NOT attempt to assemble the kit if parts are missing or damaged. • DO NOT return the product to the store. For assistance or replacement parts call: 1-800-336-2383. BEFORE YOU BEGIN: Check your local zoning laws.
PAGE 3
1. Layout Installation: Fig. 1 • Establish your fence line by staking out the areas you wish to enclose. Locate each point in which you will need an end, corner or gate post and mark it with a stake (Fig. 1). • For 6' sections using 2" posts: measure 723⁄4" from the center of an end point and mark with stake (Fig. 2). NOTE: • Installing on sloped terrain will reduce distance between posts.
PAGE 4
3. Post Location: Fig. 4 Measure the width of the fence panel (X) plus the width of the post (Y). This is the common centerto-center measurement (unless there is a cut-down panel) for post hole location (Fig. 4). X Y Post Installation: Dig first two post holes 6" in diameter and down to your specified frost line. Insert filler/gravel into the bottom of both holes and then set first post in post hole.
PAGE 5
1. Panel/Post Installation: As the post is setting up, install the first fence panel. Insert the horizontal rails from the panel into the punched holes from the previously installed post. Place the rails as far into the post as they will go (Fig. 1). Fig. 1 Post Rail Rail Top view of post 2. Place the next required post into the dug hole, and slide the post onto the rails of the panel as far as possible. Fig. 2 Plumb and level the post and add concrete according to manufacturer's instructions. 3.
PAGE 6
Barrette Outdoor Living 545 Tilton Rd, Egg Harbor City, NJ. 08215 barretteoutdoorliving.com • (800) 336-2383 REV 11.