Instruction Manual

THIS MANUAL IS FOR USE WITH SYSTEM 64004

GALE BANKS ENGINEERING

546 DUGGAN AVENUE • AZUSA, CA 91702

(626) 969-9600 • FAX (626) 334-1743

www.bankspower.com

TACHOMETER

GAUGES

OWNERS

MANUAL

WITH INSTALLATION

INSTRUCTIONS

PAGE 1
OWNERS MANUAL WITH INSTALLATION INSTRUCTIONS TACHOMETER G A U G E S THIS MANUAL IS FOR USE WITH SYSTEM 64004 GALE BANKS ENGINEERING 546 DUGGAN AVENUE • AZUSA, CA 91702 (626) 969-9600 • FAX (626) 334-1743 www.bankspower.com ©1999 GALE BANKS ENGINEERING 09/01/99 P.N.
PAGE 2
GENERAL INSTALLATION PRACTICES 1. For ease of installation, please read this entire 3–page manual before starting any work. Become thoroughly familiar with all components and phases of the installation to determine what additional tools or materials you will need. This manual is an installation guide for all Banks Tachometer Gauges. For each segment of gauge installation, select the text that closest corresponds to your vehicle.
PAGE 3
In vehicles which require the magnetic sensor to be installed on the crankshaft damper, the red wire from the gauge is to be connected to a key-on power source within the vehicle. Make sure, with a test light or volt meter, that the source only has +12V when the key is on. Run two #20 AWG wires from the magnetic pickup to the gauge, and connect one of the wires to each of the black and white wires coming from the gauge. The black wire from the gauge also needs to be connected to vehicle ground. 5.
PAGE 4
This page intentionally left blank.