User's Manual

3.4 Set Up

Once both the Baby and Parent Units are switched on, the display on the Parent Unit will show the video

captured by the Baby Unit(s).

Baby Unit(s) are paired to the Parent Unit when supplied. There is no need to pair the units again unless the

Baby Unit loses its link with the Parent Unit. To renew the pairing of your units or pair a new/additional Baby

Unit, follow the procedure described in "Section 4.4 Pairing the Baby Unit (Camera) with the Parent Unit".

The Baby Unit should be placed at least 6 feet away from the baby's crib on a ﬂat surface. Alternatively, it

can be wall mounted.

Never place the Baby Unit inside the crib, bed or playpen.

Make sure the unit and cords are out of reach of the baby and other young children.

To avoid a strangulation hazard, the power cords should be secured and never hung on the crib or near the

baby.

Place the baby monitor in a place where the air can circulate freely and avoid blocking the ventilation and

speaker openings.

Aim the camera(s) to best optimize the viewing area: Select a location for the camera that provides a clear

view of the area you want to monitor, which is free from dust, and is not in line-of-sight to a strong light

source or direct sunlight. Avoid installing the camera where there are thick walls or obstructions between the

camera and the monitor.

To use your Parent Unit and Baby Unit together, you must be able to establish a radio link between them; the

range may be affected by environmental conditions/obstacles (See more details in Troubleshooting Section 6 -

“Interference or poor reception”)

Press to access the menu, choose and press

Press the lullaby you want to play.

Navigate with to select the desire duration and music volume.

In order to stop the lullaby playback, select

Press to exit the menu.

You can soothe your baby to sleep by playing 5 pre-programmed lullabies from the Baby Unit.

The monitor also features White Noise, which is an effective way to soothe a crying infant and lull your

newborn to sleep. The Lullaby and White Noise features are is controlled remotely from the Parent Unit.

4.1 Lullaby & White Noise Setting

4. Operating the Monitor