TDC Burst 6 DMX LED light effect User manual
Safety instructions WARNING! Always keep this device away from moisture and rain! Hazardous electrical shocks may occur! WARNING! Only connect this device to a matching power outlet. This device is intended to work on a specified AC currency. Connecting this device to power outlets with other voltages may result in permanent damage and possible hazardous situations, such as fire or electrical shocks! WARNING! Be careful with every operation of this device.
- Only handle the power cord by its connectors. Never pull the cable to remove a connector from its socket, as this could lead to damage and electrical shocks. - Always operate this device with a stable AC current. - Always operate this device with the AC ground wire connected to the electrical system's ground. - Never use other types of cables than specified in the manual, do not use defective or bad functioning cables.
Box contents Box contents 1x TDC Burst 6 fixture 1x power cable 1x mounting bracket 1x hardware for mounting bracket Unit and accessory inspection - Always use the supplied power cable to connect the unit to a power supply. If the cable appears broken or has visible damage, do not use it. - If the unit is not going to be used for a longer period of time, disconnect it from the power supply and store it in a dust-free environment. - Always check the unit for possible damage before use.
Device overview 2 3 4 1 5 6 1. Beam output 2. Adjustable bracket 3. Menu display with buttons 4. Safety eye 5. DMX input (3p XLR) 6. DMX output (3p XLR) 7. Built-in microphone 8. IEC output (power link) 9.
Setting up the unit To activate the unit, connect the included power supply to the unit and a suitable 230V, 50 Hz power outlet. The fixture will start up and show the last chosen setting on the display. Usually, with a new product, this is the DMX mode with the value set on 001. The display shows several settings, each with the possibility to set several values. Use the display and the menu buttons to set preferences, change settings and scroll through the menu.
The TDC Burst 6 is equipped with several working modes, each with its own advantages. For simple events there are stand-alone modes, for advanced situations there are options to create synchronized lightshows, or controlled with a DMX-512 controller. A short description for each mode can be found below: Auto: Automatic lightshow with a pre-programmed internal show, on a pre-defined speed.
Technical specifications - Light effect with dozens of moving, colourful and narrow beams Light source: 9W RGB LED chip Fills the room with an immense amount of fast or slow moving beams Razorsharp optics for intense beam projections Individual LED colour control with fluent dimmers, for creative colour combinations.