User's Manual

U-NII Config & User Guide 5.2 Axxcelera Broadband Wireless
• Delete an atmarp entry
root@cs1 11:13:42 (6) [~] # atmarp -d 192.168.100.1
3. Check the Switch for the correct PVC’s.
• Log into the ATM switch and check that the PVCs are mapped correctly. The
following commands are for an FVC switch.
• Add a PVC
ADMIN Access_NGI>set pvc add 101 0 101 be 102 0 101 be
Adding PVC i=101/0/34 o=102/0/34 to switch fabrice
Updating FLASH memory. Please wait ... Done.
• Show the PVCs mapped in the switch
ADMIN Access_NGI>show pvc list id 0
------------------------------------------------------------
PVC ID IPort IVPI IVCI BW OPort OVPI OVCI BW
------------------------------------------------------------
1 101 0 101 0 102 0 101 0
• Delete a PVC
ADMIN Access_NGI>set pvc del 1
SU
1. Check all physical connections. The radio is a network device, which means if
you connect it to a PC (NIC) you will use a straight cable. If you connect the radio to a network
device (hub, switch, router) you will use a Ethernet cross-over cable(1-3, 2-6). It is also
important to check that the cable is punched down correctly in the wall box and the cable is
terminated correctly at the radio. The termination at the radio uses 568B
(wo,o,wg,bl,wbl,g,wbr,br).
2. Make sure the computer you are pinging from is on the same network as the AP.
If you are on a different network than the radio make sure you have the proper routes in the radio
and the computer you are trying to ping from.
March 10, 2003 Company Confidential Page 108 of 149