User Manual

AXELL MBF-40 AMERICAS REPEATERS
PRODUCT DESCRIPTION AND USER’S MANUAL
VIII Doc. No. 00071UM Rev. 3.2 © Axell Wireless Ltd
Caution: Safety to
equipment
When installing, replacing or using this product, observe all
safety precautions during handling and operation. Failure to
comply with the following general safety precautions and with
specific precautions described elsewhere in this manual
violates the sa
fety standards of the design, manufacture, and
intended use of this product.
Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to
operate the equipment.
Axell Wireless assumes no liability for the customer's failure
to comply with these precautions. This entire manual should
be read and understood before operating or maintaining the
repeater.
Warning: Restricted
Access Location
Access to the Axell unit installation location is
restricted to
SERVICE PERSONNEL and to USERS who have been
instructed on the restrictions and the required precautions to
be taken.
Attention:
Electrostatic
Sensitivity
Observe electrostatic precautionary procedures.
ESD = Electrostatic Discharge Sensitive Device.
Static electricity can be conducted to the semiconductor chip
from the centre pin of the RF input connector, and through
the AC connector pins. When unpacking and otherwise
handling the repeater, follow ESD precautionary procedures
inclu
ding use of grounded wrist straps, grounded workbench
surfaces, and grounded floor mats.
Caution: Class 1
Laser
The repeaters described in this manual are equipped with
class 1 lasers, as per definition in EN 60825-1
Caution - Un-
terminated optical receptacles may emit laser
radiation. Exercise caution as follows:
• Do not stare into beam or view with optical instruments.
Optical transmitters in the Fiber optic converter can send
out high energy invisible laser radiation. There is a risk for
permanent damage to the eye.
• Always use protective cover on all cables and connectors
which are not connected.
• Never look directly into a Fiber cable or a connector.
• Consider that a Fiber can carry transmission in both
directions.
• During handling of laser cables or connections, ensure
that the source is switched off.
• Regard all open connectors with respect and direct them
in a safe direction and never towards a reflecting surface.
Reflected laser radiation should be regarded as equally
hazardous as direct radiation.