User's Manual

AXELL 3307D REPEATER
PRODUCT DESCRIPTION AND USER’S MANUAL
36 © Axell Wireless Ltd
4.7.4.2 Activating the modem in the Verizon network
WARNING!!! SETTINGS OF THE MODEM ARE SENSITIVE TO CHANGES.
INSERT VALUES AND PARAMETERS WITH PARTICULAR CARE IN ORDER TO
ENABLE THE REMOTE CONNECTION.
Below is the activation procedure for the modem in the Verizon Wireless Network.
1. Open the Repeater and connect the RS-232 cable (provided in the accessory kit) to the CMU
card.
2. Open HyperTerminal with (or eqvivalent program)
3. Set connection speed to 115,200, no flow control.
4. Type AT  and you should get a response OK.
5. Use the command ATD*22899; (ensure there is a semi-colon “;” after the dial string, otherwise
you will make a circuit data call). This will start your OTASP (Over-The-Air, Service
Provisioning) session.
The following messages should be displayed:
• +WOT1: “Programming in Progress”
• +WOTS: “SPL unlocked”
• +WOTP: “PRL download OK”
• +WOTM: “MDM download OK”
• +WOTC: “Commit successful”
• +WOT2: “Programming Successful!”
IMPORTANT* After programming, remove the RS-232 cable for proper modem function on
the Verizon network.
6. After a few minutes, a Modem IP Address should appear on the CMU GUI screen. This indicates
the modem is functioning on the Verizon Network. The module is then set up for both voice and
data.
RS-232 connection for
modem activation