Instructions / Assembly

Follow all application, safety and disposal instructions on Foam Can. Wear proper safety attire: goggles, gloves and protective clothing
STEP 1: CAN ATTACHMENT
Remove Foam Can Cap
Shake can vigorously for one minute
Screw Foam Can onto Can Adapter
Do not overtighten
REGULATOR
CAN ADAPTER
TRIGGER
NOZZLE
STEP 2: APPLY FOAM
Turn Regulator knob counter clockwise to open flow.
Aim Nozzle at desired spot.
Squeeze Trigger to apply foam
Turn Regulator knob to adjust flow of foam
Release Trigger to stop flow.
When finished, turn Regulator knob clockwise to close flow.
Spray Nozzle with Foam cleaner. Wipe off excess foam.
Store gun with partially filled can attached.
It is not recommended to store gun with empty can or no can attached.
STORING GUN WITHOUT CAN
Perform following procedures in well-ventilated area.
Unscrew & remove empty foam can.
Immediately attach Foam Gun cleaner to Can Adapter.
With Regulator knob open, squeeze Trigger until only cleaner is
released from Nozzle.
Release Trigger, wait 20-30 seconds.
Repeat process 2-3 times. No foam should be seen.
Remove Can of cleaner from gun.
Spray outside surfaces, Can Adapter and Nozzle with cleaner.
AWarehouseFull * 140 Central Avenue, Farmingdale, NJ 07727 * Tel [phone] * [e-mail]
For use with Canned Insulating Foam Sealant
AWF Pro
®
Pro Foam Gun - OPERATING INSTRUCTIONS